Development of Stand-off Imagıng Systems Using Low Cost Plasma Detectors

Date

2018-11-09

Author

Altan, Hakan

Metadata

Show full item record

Item Usage Stats

145
views

0
downloads

URI

https://hdl.handle.net/11511/74390

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Development of Stand-Off Imaging Systems Using Low Cost Plasma Detectors That Work in the GHz to THz Range Altan, Hakan; Pavia, Joao Pedro; Ribeiro, Marco; Şahin, Asaf Behzat; Kuşoğlu-Sarıkaya, Cemre (Springer-Verlag, 2021-05-01) Technologies used to detect mm-wave/Terahertz (THz) radiation range from those that are based on temperature changes, direct/indirect transitions or those that detect through the applied electric field. However, many commercially available detectors have limitations in terms of speed and responsivity and are quite expensive. For these reasons, commercially available indicator lamps which are called glow discharge detectors (GDDs) can be a good alternative since they are low cost and can detect microwave to ...
Development of Stand-Off Imaging Systems Using Low Cost Plasma Detectors That Work in the GHz to THz Range AKBAR, DEMİRAL; Altan, Hakan; Ribeiro, Marco; ŞAHİN, ASAF BEHZAT; Kuşoğlu Sarıkaya, Cemre; Pavia, Joao Pedro (Springer, 2021-01-01)
Development of half bridge module based power converters for electric machine test setups Yazıcı, Özgür; Bostancı Özkan, Emine; Department of Electrical and Electronics Engineering (2022-12-15) Electric machines need to be tested in laboratory conditions by using machine test systems in order to make sure they perform as intended. However, most of the time it is very difficult to replace the components of an electric machine test system. Usually, their mechanical design is not suitable for different frame sizes and their power converters can drive only a single type machine. So, each setup can be used with a very limited range of electrical machines. This study aims to design and implement an elec...
Development of hole transport transparent conductive electrodes for n-type crystalline silicon solar cells Akdemir, Ozan; Bek, Alpan; İmer, Muhsine Bilge; Department of Micro and Nanotechnology (2018) Conventional transparent conductive electrodes (TCEs) used in crystal silicon (c-Si) solar cells are commonly made of indium tin oxide (ITO) which provides low sheet resistance and high transparency. However, due to indium scarcity, ITO layers increase the fabrication cost; thus, alternative TCEs, such as fluorine-doped tin oxide (FTO), zinc oxide (ZnO), metal nanowires and Oxide/Metal/Oxide (OMO) multilayers, are being investigated. Conventional solar cells also make use of doped layers, to create the junc...
Development of high performance uncooled infrared detector materials Kebapçı, Başak; Akın, Tayfun; Turan, Raşit; Department of Micro and Nanotechnology (2011) This thesis reports both the optimizations of the vanadium oxide (VOx) thin film as an active infrared detector material by the magnetron sputtering deposition method and its use during fabrication of proper resistors for the microbolometers. Vanadium oxide is a preferred material for microbolometers, as it provides high TCR value, low noise, and reasonable resistance, and a number of high-tech companies have used this material to obtain state-of-the-art microbolometer arrays. This material is first used in...

Citation Formats

H. Altan, “Development of Stand-off Imagıng Systems Using Low Cost Plasma Detectors,” 2018, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/74390.