Mechanical Properties of PLA/PHA Blends for Fused Deposition Modeling Applications

Date

2018-11-09

Author

Kaygusuz, Burçin
Özerinç, Sezer

Metadata

Show full item record

Item Usage Stats

162
views

0
downloads

URI

https://aybu.edu.tr/icammen2018/
https://hdl.handle.net/11511/76950

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Mechanical Properties of 3D-Printed Elastomeric Foams Bakır, Ali Alperen; Özerinç, Sezer (2020-11-27)
Mechanical properties of nylon parts produced by fused deposition modeling Hasçelik, Sabit; Öztürk, Ömer T.; Özerinç, Sezer (2021-01-01) Fused deposition modeling (FDM) is a widely used additive manufacturing technique for producing polymeric parts. While most commonly used FDM filaments are PLA and ABS, nylon is a widely used thermoplastic polymer in industry. This study investigated the mechanical properties of FDM-produced specimens made of nylon and quantified the effect of process parameters such as raster orientation and nozzle temperature on the mechanical properties. As the nozzle temperature increases, specimens become stronger with...
Mechanical properties of poylmer/bioceramics based 3D porous scaffolds in hard tissue engineering Evis, Zafer (2018-11-09)
Mechanical Performance of Resol Type Phenolic Resin/Layered Silicate Nanocomposites Tasan, C. Cem; Kaynak, Cevdet (Wiley, 2009-03-01) Clay addition has been shown to affect polymer resins positively in terms of several physical and chemical properties, including mechanical performance, high temperature endurance and durability. These increases are limited only to relatively low concentrations of reinforcement phase, but at these low concentrations polymer/layered silicate nanocomposites (P/LS NC) have shown to exhibit higher mechanical performance than fiber reinforced polymer composites. This is among the several reasons that make P/LS N...
Mechanical properties of unsaturated polyester/montmorillonite composites Inceoglu, AB; Yılmazer, Ülkü (2001-11-29) Nanocomposites composed of unsaturated polyester matrix and organically modified clay filler were prepared. After the synthesis, XRD patterns showed that the interlayer spacing expanded from 1.25 nm to 4.5 nm. The mechanical properties of the nanocomposites were determined and it was found that adding only 3 w/w % organically modified clay improved the flexural modulus of unsaturated polyester by 35%. From DSC diagrams, it was found that T-g values of the nanocomposites also increased with the clay content....

Citation Formats

B. Kaygusuz and S. Özerinç, “Mechanical Properties of PLA/PHA Blends for Fused Deposition Modeling Applications,” 2018, Accessed: 00, 2021. [Online]. Available: https://aybu.edu.tr/icammen2018/.