Hybrid seismic base isolation design for Mississippi River bridge

2001-01-01
ASCE Structures Congress 2001,(01 Ocak 2001)

Suggestions

Hybrid Seismic Isolation Design of Sakarya-II Viaduct in the Proximity of the North Anatolian Fault
Özkaya, Cenan; Çelebi, N.; Tulumtas , F.; Dicleli, Murat (2010-07-11)
Hybrid transparent conductive electrode structure for solar cell application
Altuntepe, Ali; Olgar, Mehmet Ali; Erkan, Serkan; Hasret, Onur; Kececi, Ahmet Emin; Kokbudak, Gamze; TOMAKİN, MURAT; Seyhan, Ayse; Turan, Raşit; Zan, Recep (2021-12-01)
This study draws on our experiences with graphene to perform a hybrid TCO structure composed of AZO and graphene. We first set out to enhance the electrical and optical properties of AZO to enable its use especially in the field of solar cell. Hence, in our study, we deposited various thicknesses of AZO thin films on glass substrates and transferred single layer graphene on them to realize the formation of hybrid TCO structure. Among the various AZO film thicknesses, the optimum one, 300 nm, was determined ...
HYBRID BEAMFORMING WITH TWO BIT RF PHASE SHIFTERS IN SINGLE GROUP MULTICASTING
Demir, Özlem Tuğfe; Tuncer, Temel Engin (2016-03-25)
In this paper, an efficient hybrid beamforming architecture combining analog and digital beamforming is proposed to reduce the number of radio frequency (RF) chains. It provides a good compromise between the higher degree of freedom of digital beamforming and hardware cost and complexity. In this hybrid system, two bit RF phase shifters are used as analog beamformers due to the fact that this enables the conversion of the combinatorial optimization problem to a continuous programming formulation. The overal...
Hybrid Ground Motion Simulations for the Western Part of Turkey (Duzce) and Building Response Estimation
Karım Zadeh Naghshıneh, Shaghayegh; Ozlu, Ekin; Askan Gündoğan, Ayşegül (null; 2018-05-14)
Hybrid Integration of Broadband Silicon Modulators and InGaAs Photodetectors
Karaca, Utku; Gövdeli, Alperen; Kocaman, Serdar (2018-10-04)
We present on-chip integration of silicon modulators and InGaAs photodetectors via flip-chip bonding. Modulators fabricated on silicon-on-insulator (SOI) and photodetectors grown on InP wafers were fabricated independently and the hybrid integration was achieved by the deposition of indium (In) bumps on both sides.
Citation Formats
M. Dicleli, “Hybrid seismic base isolation design for Mississippi River bridge,” Washington, Amerika Birleşik Devletleri, 2001, p. 1, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/77471.