Comparison of Preconcentration Technologies for Mine Mill Integration

2010-03-01
Klein, B
Bamber, A S
Weatherwax, T
Altun, Naci Emre
Sensor-Based Sorting 2010 (Sensorgestützte Sortierung 2010), 9 - 11 Mart 2010

Suggestions

Comparison of leaching tests for Hazardous waste characterization
Anbaryapan, Nur; Yetiş, Ülkü; Ünlü, Kahraman; Department of Environmental Engineering (2001)
Comparison of terahertz technologies for detection and identification of explosives
Beigang, Rene; Biedron, Sandra G.; Dyjak, Slawomir; Ellrich, Frank; Haakestad, Magnus W.; Huebsch, Daniel; Kartaloglu, Tolga; Ozbay, Ekmel; Ospald, Frank; Palka, Norbert; Puc, Uros; Czerwinska, Elzbieta; Sahin, Asaf B.; Sesek, Aleksander; Trontelj, Janez; Svigelj, Andrej; Altan, Hakan; van Rheenen, Arthur D.; Walczakowski, Michal (2014-05-06)
We present results on the comparison of different THz technologies for the detection and identification of a variety of explosives from our laboratory tests that were carried out in the framework of NATO SET-193 “THz technology for stand-off detection of explosives: from laboratory spectroscopy to detection in the field” under the same controlled conditions. Several laser-pumped pulsed broadband THz time-domain spectroscopy (TDS) systems as well as one electronic frequency-modulated continuous wave (FMCW) d...
Comparison of compressive strength test procedures for blended cements
Ülker, Elçin; Yaman, İsmail Özgür; Öztürk, Abdullah; Department of Cement Engineering (2010)
The aim of this thesis is to twofold, in order to demonstrate the variabilities that can be faced within the compressive strength of blended cements, one blended cement namely CEM IV / B (P-V) 32.5N is selected and the 28-day compressive strength is obtained by 16 different laboratories following TS EN 196-1 standard. Later, to show the variabilities that could be faced by different standards, three different cement types were selected and their compressive strengths are determined following two procedures ...
Comparison of Inverter Topologies Suited for Integrated Modular Motor Drive Applications
Ugur, Mesut; Sarac, Hakan; Keysan, Ozan (2018-08-30)
In this paper, various inverter topologies are compared for integrated modular motor drive (IMMD) applications. Two-level voltage source inverter (2L-VSI), three level voltage source inverter (3L-VSI) and series/parallel combinations of these topologies with system level modularity are compared in terms of voltage and current harmonic spectrum, passive component sizes and motor drive efficiency. New generation wide band-gap GaN power semiconductor devices are utilized in modular topologies and they are comp...
Comparison of advanced modulation schemes for LEO satellite downlink communications
Belce, O (2003-11-22)
The M.Sc. degree project, whose one major part is explained in this paper, has been accomplished at the University of Surrey by the financial support of TUBITAK-BILTEN inclusive to the remote sensing satellite project BILSAT-1*, which was carried out by Surrey Satellite Technology Limited in UK, collaboration with TUBITAK-BILTEN. This paper explains the methodology and the simulation results of the performances of advanced modulation techniques under the implications of highly dynamic LEO satellite downlink...
Citation Formats
B. Klein, A. S. Bamber, T. Weatherwax, and N. E. Altun, “Comparison of Preconcentration Technologies for Mine Mill Integration,” presented at the Sensor-Based Sorting 2010 (Sensorgestützte Sortierung 2010), 9 - 11 Mart 2010, 2010, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/80670.