Optimization of Isolation Bearing Parameters for Effective Mitigation of Seismic Risk for Bridges

26th Annual International Bridge Conference (14 Haziran 2009)


Optimization of cutting conditions for multi-pass turning and single-pass milling operations
Zümrüt, Yavuz; Kılıç, Engin S.; Department of Mechanical Engineering (1992)
Optimization of suspension parameters to improve impact harshness of road vehicles
Aydin, Mert; Ünlüsoy, Yavuz Samim (2012-05-01)
This paper illustrates the development and implementation of a parameter optimization methodology to improve impact harshness (IH) of road vehicles. A full ADAMS model of a small commercial vehicle is used as the IH test vehicle. The methodology involves the use of design of experiments methods together with response surface methodology. Significant design parameters affecting IH of the vehicle are first determined by the screening experiments. Once the critical parameters are identified, they are optimized...
Optimization of Vortex Promoter Parameters to Enhance Heat Transfer Rate in Electronic Equipment
Ayli, Ece; Bayer, Özgür (ASME International, 2020-04-01)
In this paper, optimization of the location and the geometry of a vortex promoter located above in a finned surface in a channel with eight heat sources is investigated for a Reynolds number of 12,500 < Re < 27,700. Heat transfer rates and the corresponding Nusselt number distributions are studied both experimentally and numerically using different vortex promoter geometries (square, circular, and triangular) in different locations to illustrate the effect of vortex promoter on the fluid flow. Optimization ...
Optimization of ETV-ICP(TOF)MS and transient signal profiles for reducing isobaric interferences
Ertaş, Gülay (Royal Society of Chemistry (RSC), 2005-01-01)
One of the advantages of the ETV sample introduction is the ability to temporally separate analyte elements in complex mixtures by differences in their vaporization temperatures within the ETV for ICPMS. However, the broadening of the transient peaks in the transport tubing often obscures this temporal resolution. This study shows that decreasing the transport tubing diameter produces little broadening beyond that produced during aerosol production in the ETV. Maintaining such narrow peaks through the trans...
Optimization of Pyrolysis and Liquid Silicon Infiltration Parameters for the Processing of C C SiC Composites
Tulbez, Simge; Esen, Ziya; Dericioğlu, Arcan Fehmi (2016-11-25)
The aim of the current study is to investigate the production and characterization of Carbon Fiber Reinforced Silicon Carbide (C/C-SiC) Matrix Composites. Liquid silicon infiltration (LSI) method was utilized to produce the C/C-SiC composites. Processing of these composites via LSI process contains there main steps: Carbon Fiber Reinforced Polymer (CFRP) composite production, pyrolysis and liquid silicon infiltration. Each production step has an important effect on the efficiency of the LSI process, therefo...
Citation Formats
M. Dicleli, “Optimization of Isolation Bearing Parameters for Effective Mitigation of Seismic Risk for Bridges,” Pennsylvania, Amerika Birleşik Devletleri, 2009, p. 1, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/83095.