Optimum Blank Design in Deep-Drawing

1992-07-15
Darendeliler, Haluk
KAFTANOĞLU, BİLGİN
Proceedings of the 2nd International Conference on Automation Technology

Suggestions

OPTIMUM DESIGN OF FRAMES
ERBATUR, F; ALHUSSAINY, MM (Elsevier BV, 1992-12-03)
In this paper optimum design of frames is discussed. Specifically, minimum weight design of steel frames in the elastic range of material behaviour is treated. The solution algorithm is designed and programmed for use on micro-computers to suit a design office environment. Stress and slenderness constraints are considered, however displacement constraints may readily be implemented. Three examples are given and the results are discussed.
Optimum dragline selection for strip coal mines
Erdem, B; Celebi, N; Pasamehmetoglu, AG (1998-01-01)
A model is presented by means of which the optimal dragline selection may be made. An outline is given of the methodology that was adopted in developing a series of generic algorithms to first define and then formularize the need to extend the working bench under a nat-lying topography and coal seam. Rehandle percentages were calculated for four generalized extended bench geometries, in each of which the percentage rehandle varied according to the relative positions of the extended bench and pit. A set of g...
Optimum geometry for torque ripple minimization of switched reluctance motors
Sahin, F; Ertan, Hulusi Bülent; Leblebicioğlu, Mehmet Kemal (2000-03-01)
For switched reluctance motors, one of the major problems is torque ripple which causes increased undesirable acoustic noise and possibly speed ripple. This paper describes an approach to determine optimum magnetic circuit parameters to minimize low speed torque ripple for such motors. The prediction of torque ripple is based on a set of normalized permeance and force data obtained from numerical field solution for doubly-salient geometries. For that purpose a neural net is trained to extract the data neede...
Optimum geometry for torque ripple minimization of switched reluctance motors
Şahin , Funda; Leblebicioğlu, Kemal; Ertan, H. Bülent; Department of Electrical and Electronics Engineering (1996)
Optimum geometry for torque ripple minimization of switched reluctance motors
Sahin, F; Ertan, HB; Leblebicioğlu, Mehmet Kemal (Emerald, 1995-12-01)
This paper briefly describes an approach to determine the optimum magnetic circuit parameters to minimize low speed torque ripple for switched reluctance (SR) motors. For prediction of the torque ripple, normalized data obtained from field solution and a neural network approach is used. Comparison of experimental results with computations illustrates the accuracy of the method. The optimization method is briefly described and some results are presented.
Citation Formats
H. Darendeliler and B. KAFTANOĞLU, “Optimum Blank Design in Deep-Drawing,” presented at the Proceedings of the 2nd International Conference on Automation Technology, Taipei, Tayvan, 1992, Accessed: 00, 2022. [Online]. Available: https://hdl.handle.net/11511/97155.