Conversion of transmission lines from Conventional to bundled operation.

1966
Cultu, Mehmet
Show full item record
39
views
0
downloads
https://hdl.handle.net/11511/10250
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Conversion of a conventional general purpose lathe to A.C.N.C lathe.
Bumin, Feyhan F; Department of Mechanical Engineering (1985)
Adaptation of Renewable Based Power Plants to the Energy Market Using Battery Energy Storage Systems
Durna, E.; Parlak, D.; Logoglu, E. Uz; Gercek, C. O. (2014-10-22)
This paper presents a method for the adaptation of a wind power plant to the energy market using battery energy storage systems (BESS) to show the feasibility of using fast-response batteries, and to calculate its payback period. The proposed method is also used to investigate the optimum battery size according to the installed capacity of the wind farm based on the price and wind forecast, and arbitrage opportunity so as to maximize the profit of the investor. The profit obtained from the market by the bat...
Utilization of geothermal engergy for residential heating.
Kutan, Isamil Zekai; Department of Mechanical Engineering (1977)
Adaptation of water distribution networks for urban renewal
Çelik, Mustafa Ertan; Merzi, Nuri; Department of Civil Engineering (2015)
Urban renewal managed by Turkish Municipalities and Housing Development $GPLQLVWUDWLRQ 72.ø) causes increase in water consumption at particular nodes. This study aims to find permissible increase in discharge at a single node without affecting other nodes in Yayla neighborhood, which is part of N8.3 pressure zone. Initially, capacity of existing water distribution network should be investigated to determine whether consumption increase at particular nodes affects the system. Peak discharge drawn from N8.3 ...
Upgrading of slab-column connections using fiber reinforced polymers
Binici, Barış (Elsevier BV, 2005-01-01)
The results of an experimental program on upgrading of reinforced concrete slab-column connections subjected to monotonic shear and unbalanced moment transfer are presented in this study. Externally installed carbon fiber reinforced polymer (CFRP) stirrups acting as shear reinforcement around the slab-column connection area were used with two patterns of CFRP arrangements. It was found that the proposed method resulted in punching shear capacity increases up to 60% relative to the specimen without any stren...
Citation Formats
M. Cultu, “Conversion of transmission lines from Conventional to bundled operation.,” Middle East Technical University, 1966.
METU IIS - Integrated Information Service open@metu.edu.tr