Optimization of base plates for steel poles

Download
068608.pdf
1997
Uzman, Alper
Show full item record
134
views
0
downloads
https://hdl.handle.net/11511/10396
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Optimization of the geometry and material of solar water heaters
Zilan, Ruken; Ecevit, Ahmet; Department of Physics (2001)
Optimization of vibration characteristics of a radar antenna structure
Baran, İsmet; Özgen, Gökhan Osman; Ciğeroğlu, Ender; Department of Mechanical Engineering (2011)
Radar antenna structures especially array antennas which are integrated onto structures of aerial vehicles are subject to dynamic structural and aerodynamic loads. Due to occurrences of these dynamic loads there will be certain dynamic deformations which affect the antenna’s performance in an adverse manner. The influence of deformations and vibrations are important on array antenna structures, since they cause a change in orientation of elements of the phased array antenna which affects the gain of the ant...
Optimization of laser beam welding of un and high alloyed steel sheets
Batıgün, Caner; Ankara, Alpay; Department of Metallurgical Engineering (1994)
OPTIMIZATION OF COMPOSITE BOLTED JOINT DESIGN
ANKARA, AO; DARA, BG (1994-06-01)
An investigation for the development of an interactive computer program for the assessment of strength of a single fastener composite joint in single shear was carried out. Database from previous experimental programs and design sources was evaluated for the establishment of the program. Some experiments were also done with single shear bolted carbon fiber reinforced composite laminates. The suggested computer program models the joint behavior by considering the laminates as homogeneous plates with represen...
Optimization of macrostructure in aluminium foams
Tan, Serdar; Öztürk, Tayfur; Department of Metallurgical and Materials Engineering (2003)
Pure aluminium and aluminium-5wt % TiO2 aluminium foams were produced by powder metallurgy technique with the use of TiH2 as foaming agent. Two sizes of TiH2 were used: 20æm and 3æm. It has been confirmed that high level of compaction is the primary requirement in foaming. It was shown that hot swaging could be used as a method of compaction for foaming as it leads to values close to full density. Pure aluminium foamed at 675°C and 725°C leads to a volume expansion between 90-180 %. A model was developed fo...
Citation Formats
A. Uzman, “Optimization of base plates for steel poles,” Middle East Technical University, 1997.
METU IIS - Integrated Information Service open@metu.edu.tr