Determination of the total amount of dust and it's concentration dispersion after blasting in surface mines

Uyar, Güzin Gülsev


Determination of the Load Share and Coefficient of Friction in Mixed Lubrication Regime
Akkök, Metin (2012-05-22)
Determination of econamical diameter of steel penstocks in hydropower plants
Kutluay, Lutfi; Günyaktı, Ali; Department of Civil Engineering (1991)
Determination of instantaneous breaking rate by Geological Strength Index, Block Punch Index and power of impact hammer for various rock mass conditions
Aksoy, C. O.; Ozacar, V.; Demirel, Nuray; Ozer, S. C.; Safak, S. (Elsevier BV, 2011-07-01)
In mining and construction industries, selection of appropriate excavation method and equipment significantly affects the project feasibility. In the selection, the most important parameters are the geomechanical properties of the rock mass in the excavation route as extensively reviewed in literature. The most widely used geomechanical parameter is uniaxial compressive strength (UCS). However, UCS laboratory test requires time consuming and expensive sampling and core sample preparation processes, which ca...
Determination of degree of mixing in solid rocket propellants
Yeşilırmak, Yener; Yılmazer, Ülkü; Department of Chemical Engineering (2006)
Composite propellants are mainly composed of: crystalline oxidizer, metallic fuel, and polymeric binder. Additives, such as plasticizers, catalysts, bonding agents and curing agents may also be incorporated to propellant compositions in small amounts. These ingredients should be mixed rigorously in order to obtain a uniform microstructure throughout the cast propellant profile. The quality of the propellant mixture has to be determined quantitatively to improve the product quality and to reduce costs. In th...
Determination of surface temperature rise with thermo-elastic analysis of spur gears
Taburdagitan, Murat; Akkök, Metin (2006-09-20)
The tooth surface temperature rise during meshing spur gear pair due to frictional heat is investigated. A coupled thermo-elastic analysis is carried out by considering the elastic deformation of teeth and corresponding load shearing between the contacting tooth pairs and heat generation in the contact. In the analysis, gear pairs with contact ratio between one and two are considered and pinion and gear are modeled only with three teeth. The finite element analysis is performed using quadrilateral 4-node pl...
Citation Formats
G. G. Uyar, “Determination of the total amount of dust and it’s concentration dispersion after blasting in surface mines,” Middle East Technical University, 1996.