The effect of metallurgical factors on the abrasive wear resistance of AISI 1040, 4340 and 5140 steels

Download
1988
Dikmen, Deniz

Suggestions

The effect of retained austenite on the abrasive wear resistance of aisi 52100 steels
Büget, Cem; Atala, Haluk; Department of Metallurgical Engineering (1993)
The Effect of Microstructure and Content of Second Phases on the Corrosion Behaviour of Nickelless Stainless Steels
Mehrabov, Amdulla; Aivazov, Bilayet; Aliyev, Maksut (null; 1999-06-10)
THE EFFECT OF REUSED POWDER CHARACTERISTICS ON THE PROPERTIES OF ADDITIVELY MANUFACTURED 17-4 PH STAINLESS STEEL
Kahraman, Ece; Ögel, Bilgehan; Yasa, Evren; Department of Metallurgical and Materials Engineering (2022-4-25)
Powder bed additive manufacturing methods use the powder form of the material of the part to be produced as raw material. The quality of the production is highly dependent on the properties of the powder used in the first place. Consistently using new unused powder for each new additive manufacturing is costly and removes the advantage of additive manufacturing, i.e. low amount of waste material. In powder bed additive manufacturing methods, powders are laid layer by layer and melted by laser or electron be...
The effect of SN content and isothermal transformation temperature on the mechanical properties of austempered ductile cast iron
Özcan, Alper; Atala, Haluk; Department of Metallurgical and Materials Engineering (2003)
In this study the effects of Sn content and isothermal transformation temperature on the ultimate tensile strength (UTS), elongation and hardness of austempered ductile cast iron (ADI) was investigated. To determine the possible effect of Sn on these properties the Sn content of standard GGG30, GGG40 and GGG50 materials were taken as reference, whose chemical compositions vary from 0,016 to 0,050% in terms of Sn. However the Sn content was increased to a maximum of 0,26% for investigating the effect of Sn o...
The effect of double austenitization on microstructure and fracture toughness of AISI M2 high speed steel
Ögel, Bilgehan; Tekin, Erdoğan; Department of Metallurgical Engineering (1990)
Citation Formats
D. Dikmen, “The effect of metallurgical factors on the abrasive wear resistance of AISI 1040, 4340 and 5140 steels,” Middle East Technical University, 1988.