Development of a novel sorbent for hot gas desulfurization

Download
075799.pdf
1998
Derinöz, Canan
Show full item record
148
views
0
downloads
https://hdl.handle.net/11511/1926
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Development of a novel regenerable sorbent for hot gas desulfurization
Aksoy, Ayşegül; Atımtay, Aysel; Department of Environmental Engineering (1994)
Development of a novel regenerable zinc ferrite sorbent for hot gas desulfurization
Aksoy, Ayşegül (null; 1995-06-02)
Integrated Gasification Combined Cycle System (IGCC) promises efficient, clean and economical electrical power generation. In this system coal is gasified under high temperature and pressure. The coal gas exiting the gasifier is cleaned from the particulates and sulfurous compounds with a `Hot Gas Cleanup` system in which metal oxide sorbents are used to remove H{sub 2}S. The cleaned gas is then used to run the gas turbines and the recovered heat is used to run the steam turbines to generate electricity wit...
Development of new binder for the processing and sintering of tungsten carbide cermets
Aydoğan, Mehmet Emrah; Timuçin, Muharrem; Department of Metallurgical and Materials Engineering (1999)
Development of bifunctional catalyst for the single-step synthesis of dimethyl ether
Şener, Mehmetali İlker; Sezgi, Naime Aslı; Department of Chemical Engineering (2019)
Depletion of fossil fuels, global warming concerns and increasing CO2 emissions necessitated the utilization of syngas in the production of alternative fuels over the last few years. Dimethyl ether (DME) is considered as promising diesel substitute or LPG additive due to its high cetane number and good burning properties. The single-step DME synthesis method, which involves consecutive methanol formation and methanol dehydration reactions, enables the production of DME directly from the syngas. Despite the ...
Development of a novel surface damping treatment
Eyyüpoğlu, Kemal Okan; Özgen, Gökhan Osman; Department of Mechanical Engineering (2016)
Constrained layer surface damping treatments techniques have been widely used in commercial and defense products to increase the damping performance. It is known that the performance of surface damping treatments highly depend on the strain energy in the viscoelastic layer. As the strain energy in the viscoelastic layer increases, the energy dissipation magnifies which results in higher damping performance. A good way to magnify strain energy in viscoelastic layer is to increase the distance between the vis...
Citation Formats
C. Derinöz, “Development of a novel sorbent for hot gas desulfurization,” Middle East Technical University, 1998.
METU IIS - Integrated Information Service open@metu.edu.tr