A microstructural study of hot pressed PM aliminum-copper and aliminum-copper-siliconcarbide composites

Download
076048.pdf
1998
Bolay, Kübra
Show full item record
118
views
0
downloads
https://hdl.handle.net/11511/1970
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

A parametric comparative study of electrocoagulation and coagulation of aqueous suspensions of kaolinite and quartz powders
Gülsün Kılıç, Mehtap; Hoşten, Çetin; Department of Mining Engineering (2009)
Mineral treatment processes generally produce wastewaters containing ultrafine and colloidal particles that cause pollution upon their discharge into environment. It is essential that they should be removed from the wastewater before discharge. This study was undertaken by using synthetic turbid systems containing kaolinite and quartz particles in water with the amount of 0.20 g/L and 0.32 g/L, respectively. Removal of the turbidity was tried in two ways; electrocoagulation with aluminum anode and conventio...
A metallographic study of centrifugally cast naphtha cracking tubes
Doğan, Umran Bülent; Tekin, Erdoğan; Department of Metallurgical Engineering (1992)
A metallographic study of carbides in chromium modified hadfield steels
Eşlisoy, Nedim; Tekin, Erdoğan; Department of Metallurgical Engineering (1988)
A finite element parametric study on block shear failure of steel tension members
Topkaya, Cem (2004-11-01)
Block shear is a limit state that should be accounted for during the design of steel tension members. Current design equations are not based on analytical findings and fail to predict failure modes of tested specimens. A study has been conducted to develop simple block shear load capacity prediction equations that are based on finite element analysis. Over a thousand nonlinear analyses were performed to identify the important parameters that influence block shear capacity. In addition, the effects of eccent...
A numerical study of solidification and viscous dissipation effects on polymer melt flow in plane channels
Tutar, Mustafa; Karakuş, Ali (Walter de Gruyter GmbH, 2013-04-01)
The combined effects of solidification and viscous dissipation on the hydrodynamic and thermal behavior of polymer melt flow during the injection process in a straight plane channel of constant cross section are numerically studied by considering the shear-rate and temperature-dependent viscosity and transient-phase change behavior. A numerical finite volume method, in conjunction with a modified form of the Cross constitutive equation to account for shear rate, temperature-dependent viscosity changes and a...
Citation Formats
K. Bolay, “A microstructural study of hot pressed PM aliminum-copper and aliminum-copper-siliconcarbide composites,” Middle East Technical University, 1998.
METU IIS - Integrated Information Service open@metu.edu.tr