Design and construction of a high voltage impulse divider

Download

082721.pdf

Date

1999

Author

Özdemir, Kerem

Metadata

Show full item record

Item Usage Stats

186
views

0
downloads

URI

https://hdl.handle.net/11511/2062

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

Design and construction of a teleprotection system Çamkerten, Hami; Department of Electrical Engineering (1984)
Design and implementation of an annular acoustic levitation system Kandemir, Mehmet Hakan; Çalışkan, Mehmet; Department of Mechanical Engineering (2014) In standing wave acoustic levitation technique, a standing wave is obtained between a source and a reflector. Particles can be attracted towards pressure nodes in standing waves owing to the spring action. Hence, particles can be suspended in air. This operation can be performed on continuous structures as well as in several numbers of axes. In this study an annular acoustic levitation set-up is designed and built. The set-up consists of two langevin type piezoelectric transducers, two waveguides, an annula...
Design and implementation of a triple-band re-configurable microstrip antenna Onat, Sinan; Alatan, Lale; Demir, Şimşek (2006-09-12) A hybrid combination of RF MEMS and microstrip patch triple band inset-fed reconfigurable antenna is presented. A rectangular slot is placed on the antenna to obtain a dual frequency antenna. Furthermore, MEMS switches are placed on the slot to change the electrical length of the slot and obtain a third resonance frequency. Similarly, MEMS switches are used in the inset to match the antenna input impedance at different frequencies. All of the parts are manufactured and the hybrid structure will be built.
Design and fabrication of a high gain, broadband microwave limiting amplifier module Kılıç, Hasan Hüseyin; Demir, Şimşek; Department of Electrical and Electronics Engineering (2011) Microwave limiting amplifiers are the key components of Instantaneous Frequency Measurement (IFM) systems. Limiting amplifiers provide constant output power level in a wide input dynamic range and over a broad frequency band. Moreover, limiting amplifiers are high gain devices that are used to bring very low input power levels to a constant output power level. Besides, limiting amplifiers are required to provide minimum small signal gain ripple in order not to reduce the sensitivity of the IFM system over t...
Design and implementation of a medium voltage thyristor controlled reactor Utalay, M Volkan; Ermiş, Muammer; Department of Electrical and Electronics Engineering (1996)

Citation Formats

K. Özdemir, “Design and construction of a high voltage impulse divider,” Middle East Technical University, 1999.