A Miniature VGA SWIR Camera using MT6415CA ROIC

2014-05-08
Eminoglu, Selim
Yılmaz, Sibel
Kocak, Serhat
This paper reports the development of a new miniature VGA SWIR camera called NanoCAM-6415, which is developed to demonstrate the key features of the MT6415CA ROIC such as high integration level, low-noise, and low-power in a small volume. The NanoCAM-6415 uses an InGaAs Focal Plane Array (FPA) with a format of 640 x 512 and pixel pitch of 15 mu m built using MT6415CA ROIC. MT6415CA is a low-noise CTIA ROIC, which has a system-on-chip architecture, allows generation of all the required timing and biases on-chip in the ROIC without requiring any external components or inputs, thus enabling the development of compact and low-noise SWIR cameras, with reduced size, weight, and power (SWaP). NanoCAM-6415 camera supports snapshot operation using Integrate-Then-Read (ITR) and Integrate-While-Read (IWR) modes. The camera has three gain settings enabled by the ROIC through programmable Full-Well-Capacity (FWC) values of 10.000 e-, 20.000 e-, and 350.000 e-in the very high gain (VHG), high-gain (HG), and low-gain (LG) modes, respectively. The camera has an input referred noise level of 10 e- rms in the VHG mode at 1 ms integration time, suitable for low-noise SWIR imaging applications. In order to reduce the size and power of the camera, only 2 outputs out of 8 of the ROIC are connected to the external Analog-to-Digital Converters (ADCs) in the camera electronics, providing a maximum frame rate of 50 fps through a 26-pin SDR type Camera Link connector. NanoCAM-6415 SWIR camera without the optics measures 32 mm x 32 mm x 35 mm, weighs 45gr, and dissipates less than 1.8 W using a 5 V supply. These results show that MT6415CA ROIC can successfully be used to develop cameras for SWIR imaging applications where SWaP is a concern. Mikro-Tasarim has also developed new imaging software to demonstrate the functionality of this miniature VGA camera. Mikro-Tasarim provides tested ROIC wafers and also offers compact and easy-to-use test electronics, demo cameras, and hardware/software development kits for its ROIC customers to shorten their FPA and camera development cycles.

Suggestions

A Miniature Low-Cost LWIR Camera with a 160x120 Microbolometer FPA
Tepegoz, Murat; Kucukkomurler, Alper; Tankut, Firat; Eminoglu, Selim; Akın, Tayfun (2014-05-08)
This paper presents the development of a miniature LWIR thermal camera, MSE070D, which targets value performance infrared imaging applications, where a 160x120 CMOS-based microbolometer FPA is utilized. MSE070D features a universal USB interface that can communicate with computers and some particular mobile devices in the market. In addition, it offers high flexibility and mobility with the help of its USB powered nature, eliminating the need for any external power source, thanks to its low-power requiremen...
A low-cost small pixel uncooled infrared detector for large focal plane arrays using a standard CMOS process
Eminoglu, S; Tanrikulu, MY; Tezcan, DS; Akın, Tayfun (2002-04-03)
This paper reports the development of a low-cost, small pixel uncooled infrared detector using a standard CMOS process. The detector is based on a suspended and thermally isolated p(+)-active/n-well diode whose forward voltage changes due to an increase in the pixel temperature with absorbed infrared radiation. The detector is obtained with simple post-CMOS etching steps on dies fabricated using a standard n-well CMOS process. The post-CMOS process steps are achieved without needing any deposition or lithog...
A low-cost 64x64 uncooled infrared detector array in standard CMOS
Eminoglu, S; Tanrikulu, MY; Akın, Tayfun (2003-06-12)
This paper reports the development of a low-cost, 64 x 64 uncooled infrared focal plane array (FPA) based on suspended and thermally isolated p(+)-active/n-well diodes in a standard 0.35 mum CMOS process. The array is implemented using a simple post-CMOS process that do not require any critical lithography or complicated deposition steps. The pixel is 40 mum x 40 mum in size with a fill factor of 44%, and it has a measured DC responsivity of 4970 V/W with a thermal time constant of 36 msec at 80 mToff vacuu...
A low cost uncooled infrared microbolometer focal plane array using the CMOS n-well layer
Tezcan, DS; Eminoglu, S; Akar, OS; Akın, Tayfun (2001-01-25)
This paper reports a low-cost, 256-pixel uncooled infrared microbolometer focal plane array (FPA) implemented using a 0.8 mum CMOS process where the n-well layer is used as the active microbolometer material. The suspended n-well structure is obtained by simple front-end bulk etching of the fabricated CMOS dies, while the n-well region is protected from etching by electrochemical etch-stop technique within a TMAH solution. Electrical connections to the suspended n-well are obtained with polysilicon intercon...
An 80x80 Microbolometer Type Thermal Imaging Sensor using the LWIR-Band CMOS Infrared (CIR) Technology
Tankut, Firat; Cologlu, Mustafa H.; Askar, Hidir; Ozturk, Hande; Dumanli, Hilal K.; Oruc, Feyza; Tilkioglu, Bilge; Ugur, Beril; Akar, Orhan Sevket; Tepegoz, Murat; Akın, Tayfun (2017-04-13)
This paper introduces an 80x80 microbolometer array with a 35 mu m pixel pitch operating in the 8-12 aem wavelength range, where the detector is fabricated with the LWIR-band CMOS infrared technology, shortly named as CIR, which is a novel microbolometer implementation technique developed to reduce the detector cost in order to enable the use of microbolometer type sensors in high volume markets, such as the consumer market and IoT. Unlike the widely used conventional surface micromachined microbolometer ap...
Citation Formats
S. Eminoglu, S. Yılmaz, and S. Kocak, “A Miniature VGA SWIR Camera using MT6415CA ROIC,” 2014, vol. 9070, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/48996.