On the elastic-plastic shrink fit with supercritical interference

1990
Gamer, U
Müftü, Sinan
Shrink fits with perfectly elastic-plastic hub material cannot be treated with the help of Tresca's yield criterion, if the ratio of outer and inner diameter as well as the interference exceed certain limits. For linear hardening material, however, a solution exists for all radii ratios. It is shown that, for small hardening, the material in the neighbourhood of the interface undergoes a twofold change of the yield condition.
ZAMM - Journal of Applied Mathematics and Mechanics / Zeitschrift für Angewandte Mathematik und Mechanik

Suggestions

On the elastic-plastic shrink fit rotating with supercritical angular speed
Gamer, U.; Orçan, Yusuf (Wiley, 1989)
Based on Tresca's yield criterion and the associated flow rule, the distribution of stress and displacement in the completely plasticized hub of a rotating shrink fit is studied. The hub material exhibits linear hardening. At the critical angular speed, a change in the Tresca regime takes place.
ON THE EXPANSION OF PLASTIC REGIONS IN THE ANNULAR PARTS OF A SHRINK FIT DURING ASSEMBLAGE
ORCAN, Y; GAMER, U (Wiley, 1994-01-01)
During assemblage of a shrink fit consisting of annular shaft and annular hub, partial oi complete plastic deformation of either part can occur. If a perfectly plastic annulars is about to be fully plasticized, the interface pressure and the elastic-plastic border radius of the other annulus, which mag harden isotropically in an arbitrary way, assume stationary values. In addition to that, the case of two simultaneously fully plasticized annuli of perfectly plastic behavior is studied
The shrink fit consisting of elastic hollow shaft and nonlinearly hardening elastic-plastic hub
Orcan, Y; GAMER, U (Springer Science and Business Media LLC, 1990-3)
Based on Tresca's yield criterion and the flow rule associated to it, general expressions for stresses and displacement in a shrink fit consisting of elastic hollow inclusion and elastic-plastic hub with arbitrary nonlinear isotropic hardening are derived. For two specific hardening laws—one of Ludwik type and the other of Swift type—there follows the explicit determination of stresses and displacement together with numerical results.
On the plane strain and plane stress solutions of functionally graded rotating solid shaft and solid disk problems
Eraslan, Ahmet Nedim (Springer Science and Business Media LLC, 2006-01-01)
Closed form solutions to functionally graded rotating solid shaft and rotating solid disk problems are obtained under generalized plane strain and plane stress assumptions, respectively. The nonhomogeneity in the material arises from the fact that the modulus of elasticity of the material varies radially according to two different continuously nonlinear forms: exponential and parabolic. Both forms contain two material parameters and lead to finite values of the modulus of elasticity at the center. Analytica...
MAGNETOHYDRODYNAMIC FLOW IN ELECTRODYNAMICALLY COUPLED RECTANGULAR DUCTS
Tezer, Münevver (Wiley, 1988-06-01)
In Sezgin1,2 the problems considered are the magnetohydrodynamic (MHD) flows in an electrodynamically conducting infinite channel and in a rectangular duct respectively, in the presence of an applied magnetic field. In the present paper we extend the solution procedure of these papers to two rectangular channels connected by a barrier which is partially conductor and partially insulator. The problem has been reduced to the solution of a pair of dual series equations and then to the solution of a Fredholm's ...
Citation Formats
U. Gamer and S. Müftü, “On the elastic-plastic shrink fit with supercritical interference,” ZAMM - Journal of Applied Mathematics and Mechanics / Zeitschrift für Angewandte Mathematik und Mechanik, pp. 501–507, 1990, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/51705.