Experimental investigation on machining parameters in wire electrical discharge machining (Wire E.D.M).

1985
Ardalı, Ahmet Tanju
Show full item record
76
views
0
downloads
https://hdl.handle.net/11511/5556
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Experimental investigation of axial load on low cycle fatigue performance of steel H-piles in integral bridges
Dicleli, Murat (null; 2017-08-28)
In this study, the effect of axial load on the low cycle fatigue performance of integral bridge steel H–piles is investigated. Review of literature revealed that there is no experimental research data on the effect of axial load on the low cycle fatigue performance of integral bridge steel H-piles. For this purpose, experimental studies on full scale steel H-pile specimens are conducted to simulate cyclic behavior of steel Hpiles under thermal effects in integral bridges by considering the effect of axial l...
Experimental investigation on seismic behavior of eccentric reinforced concrete beam-column-slab connections
Canbolat, Burcu B.; Wight, James K. (2008-03-01)
Design recommendations for reinforced concrete beam-column connections are based on limited experimental studies on the seismic behavior of eccentric connections. To supplement existing information, an experimental study was conducted that focused on the affect of eccentricity of spandrel beams with respect to the column. Specimens included a floor slab and transverse beams to evaluate the effect of slab participation. Test results indicated that including the floor system significantly reduced the negative...
Experimental Investigation of Thermal Performance of an Aluminum Flat-Grooved Heat Pipe
Aljanvad, Hossein; Çetin, Barbaros; Akkuş, Yiğit; Dursunkaya, Zafer (2017-08-31)
Experimental investigation for mechanical properties of filament wound composite tubes
Erdiller, Emrah Salim; Parnas, Kemal Levend; Department of Mechanical Engineering (2004)
Experimental evaluation of cable drum systems as linear motion sensors
KILIÇ, ERGİN; Dölen, Melik; Koku, Ahmet Buğra (2011-04-15)
This study evaluates cable-drum mechanisms as linear motion sensors for certain CNC applications. In this work, the dynamical attributes of a generic device are studied experimentally. The conducted research indicates that despite the significant traction force induced between the cable and its drum, small fluctuations in mechanism's speed yields a considerable (micro) slip at the interface.
Citation Formats
A. T. Ardalı, “Experimental investigation on machining parameters in wire electrical discharge machining (Wire E.D.M).,” Middle East Technical University, 1985.
METU IIS - Integrated Information Service open@metu.edu.tr