CALCULATION OF THE OVERLAP ANGLE IN SLIP ENERGY RECOVERY DRIVES USING A D,Q/ABC MODEL

Download

index.pdf

Date

1993-06-01

Author

AKPINAR, E
PILLAY, P
Ersak, Aydın

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

122
views

81
downloads

In this paper, a closed-form expression to estimate the overlap angle in a slip energy recovery system is presented. The prediction of the overlap angle is important in the case of doubly-fed induction motor drives, because of its influence on speed and torque. A closed-form expression is derived using a hybrid model of the induction motor and a dynamic model of the rotor rectifier. The ripple content of the dc link current and the inverter input voltage are neglected. The predicted results obtained using the closed form expression are verified experimentally.

Subject Keywords

Induction motor, Slip energy, Overlap angle

URI

https://hdl.handle.net/11511/62780

Journal

IEEE TRANSACTIONS ON ENERGY CONVERSION

DOI

https://doi.org/10.1109/60.222709

Collections

Department of Electrical and Electronics Engineering, Article

Suggestions

OpenMETU
Core

Calculation of parameters of single-phase PM motor for design optimization Ertan, Hulusi Bülent; Capolino, GA (2005-09-01) This paper presents methods of calculation of parameters of single-phase permanent-magnet (SPPM) motor, in terms of motor dimensions and material properties, which are utilized in the dynamic model of the motor. The intention of the study is to develop means of SPPM performance calculations, which lend themselves to be employed within a mathematical design optimization approach. The calculated parameters are compared with measured values and are shown to be accurate for the purpose of the study.
Measurement of the ratio of the production cross sections times branching fractions of B-c(+/-) -> J/psi pi(+/-) and B-+/- -> J/psi K-+/- and B(B-c(+/-) -> J/psi pi(+/-)pi(+/-)pi(-/+))/B(B-c(+/-) -> J/psi pi(+/-)) in pp collisions at root s=7 Tev Khachatryan, V.; et. al. (Springer Science and Business Media LLC, 2015-01-01) The ratio of the production cross sections times branching fractions (sigma(B-c(+/-))B(B-c(+/-) -> J/psi pi(+/-)))/(sigma(B-+/-)B(B-+/- -> J/psi K-+/-)) is studied in proton-proton collisions at a center-of-mass energy of 7TeV with the CMS detector at the LHC. The kinematic region investigated requires B-c(+/-) and B-+/- mesons with transverse momentum p(T) > 15 GeV and rapidity vertical bar y vertical bar J/psi pi(+/-)pi(+/-)pi(-/+) decay is also observed in the same data sample. Using a model-independent...
Measurement of the differential inclusive B+ hadron cross sections in pp collisions at root s=13TeV Khachatryan, V.; et. al. (Elsevier BV, 2017-08-01) The differential cross sections for inclusive production of B+ hadrons are measured as a function of the B+ transverse momentum p(T)(B) and rapidity y(B) in pp collisions at a centre-of-mass energy of 13 TeV, using data collected by the CMS experiment that correspond to an integrated luminosity of 48.1 pb(-1). The measurement uses the exclusive decay channel B+ -> J/psi K+, with J/psi mesons that decay to a pair of muons. The results show a reasonable agreement with theoretical calculations within the uncer...
Measurement of the production cross section ratio sigma(chi b2(1P))/sigma(chi b1(1P)) in pp collisions at root s=8TeV Khachatryan, V.; et. al. (Elsevier BV, 2015-04-01) A measurement of the production cross section ratio sigma(chi b2(1P))/sigma(chi b1(1P)) is presented. The chi b1 (1P) and chi b2 (1P) bottomonium states, promptly produced in pp collisions at root s = 8TeV, are detected by the CMS experiment at the CERN LHC through their radiative decays chi b1,2(1P) -> Y(1S) + gamma. The emitted photons are measured through their conversion to e(+) e(-) pairs, whose reconstruction allows the two states to be resolved. The Y(1S) is measured through its decay to two muons. A...
STARTING TRANSIENTS IN SLIP ENERGY RECOVERY INDUCTION-MOTOR DRIVES .1. FORMULATION AND MODELING AKPINAR, E; PILLAY, P; Ersak, Aydın (1992-03-01) A detailed study of the rotor phenomena including the rectifier commutation angle and inverter harmonics is facilitated by the use of the actual rotor conduction sequence variables instead of transformed variables that are used in most other IM drive systems. The starting transients of slip energy recovery IM drives comprising three stages are presented here; (a) the starting from zero speed with a starting resistor connected to the output of the rotor rectifier; (b) a transition period in which the invert...

Citation Formats

E. AKPINAR, P. PILLAY, and A. Ersak, “CALCULATION OF THE OVERLAP ANGLE IN SLIP ENERGY RECOVERY DRIVES USING A D,Q/ABC MODEL,” IEEE TRANSACTIONS ON ENERGY CONVERSION, pp. 229–235, 1993, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/62780.