Breakdown time lags in transformer oil subjected to impulse voltages.

1979
Dinçer, Sezai
Show full item record
115
views
0
downloads
https://hdl.handle.net/11511/6488
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Crack problems in a functionally graded layer under thermal stresses
Dağ, Serkan; Yahşi, O. Selçuk; Department of Mechanical Engineering (1997)
Failure analysis in adhesively bonded composite joints
Atay, Reyhan Deniz; Güvenç Yazıcıoğlu, Almıla; Department of Mechanical Engineering (2019)
In this study, swing up and stabilization of on/off type of cold gas thruster driven inverted pendulum is accomplished. First, pulse width modulator (PWM) design method is generated to obtain quasi-linear thrust output from on/off type of thruster. Than, single axis angle controller is designed. Designed angle controller and PWM scheme are tested and verified on single axis angle control test setup. Finally, an other freedom is attached to single axis test setup and rotary inverted pendulum (Furuta Pendulum...
Creep behaviour analysis of thin spray-on liners
Güner, Doğukan; Öztürk, Hasan; Department of Mining Engineering (2020)
Thin Spray-on Liner (TSL) is a relatively thin (2–5 mm) and fast-setting liner material used by spraying onto rock surfaces to support underground excavations. Areal support materials that are sprayed onto the rock, such as shotcrete or liners, are able to generate support resistance at small rock deformations and can prevent underground rockfalls from happening in the first place. However, where large ground convergence occurs, the more flexible TSLs may provide superior support over the full range of rock...
CRACK-GROWTH KINETICS OF 7050-T73651 ALUMINUM-ALLOY UNDER CONSTANT LOAD AT 150-DEGREES-C
SARIOGLU, F; ABACHI, P; DORUK, M (Springer Science and Business Media LLC, 1993-03-15)
Crack growth tests at 150-degrees-C under constant load conditions were performed on compact tension specimens of 7050-T73651 aluminium alloy. The d.c. potential drop method was employed to monitor crack lengths throughout the tests. Fracture mechanics parameters such as the stress intensity factor (K) and energy-rate line integral (C*) were used to establish correlation with the crack propagation rates. As a result of experiments it was found that crack growth rates (da/dt) versus K, over discrete ranges o...
Crack propagation in fatigue specimens containing elliptical hole.
Deveci, Recep; Department of Mechanical Engineering (1985)
Citation Formats
S. Dinçer, “Breakdown time lags in transformer oil subjected to impulse voltages.,” Middle East Technical University, 1979.
METU IIS - Integrated Information Service open@metu.edu.tr