Predicition of static-torque characterisitcs of variabla reluctance multi-stack stepping motor.

1980
Bilgin, Kemal
Show full item record
71
views
0
downloads
https://hdl.handle.net/11511/6527
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Predicition of steady-state temperature distibution of electrical machines.
Tandoğan, Vedat Sinan; Department of Electrical Engineering (1982)
Nondestructive Monitoring of Pearlite Degradation in Medium Carbon Steels by Magnetic Barkhausen Noise Method
Gür, Cemil Hakan (2017-09-06)
Cementite in steel microstructures exits in various forms such as lamellae in pearlite after normalizing, or nano-size particles in ferrite matrix after quenching-tempering, or large spheroidal particles in ferrite matrix after spheroidizing heat treatment. Any alteration in the cementite morphology influences the strength and hardness of pearlite that exists in most of the steel structures used in wide range of industrial applications. For instance, spheroidizing heat treatment is intentionally applied to ...
Receptances of non proportionally and continuously damped plates equivalent dampers method
Özgüven, Hasan Nevzat (1981-05-01)
A method for the dynamic analysis of continuously and non-proportionally damped plates is discussed. The method is quite general and suitable for various damping treatments, such as in multilayer plates with damping layers. The transverse vibrations of partially coated plates under harmonic excitation are analyzed by the proposed method. The results of the undamped modal analysis made by classical finite element methods are used in the suggested lumped parameter analysis. The receptance matrices of coated p...
NONDESTRUCTIVE MONITORING OF VARIATIONS OF RESIDUAL STRESSES IN STEEL WELDMENTS BY MAGNETIC BARKHAUSEN NOISE METHOD
Gür, Cemil Hakan; Batıgün, Caner; Çam, İbrahim (2013-07-18)
Variations of surface residual stresses as a function of weld runs in API 5L X70 steel plates were non-destructively monitored by Magnetic Barkhausen Noise (MBN) method. After each weld run, MBN signal and hardness distributions were recorded. MBN signals were converted into stress values by using a specific calibration procedure. The results were analyzed by considering microstructure investigations and hardness measurements, and then, they were compared with the results of X-ray diffraction measurements. ...
Receptances of non proportionally and continuously damped plates Reduced dampers method
Özgüven, Hasan Nevzat (Elsevier BV, 1982-12-01)
This paper presents a method for the dynamic analysis of continuously and non-proportionally damped plates in bending modes. The damping can be in the form of constrained or unconstrained layers. The method is an extension of the equivalent dampers method discussed in a previous paper, in which the damping matrix of a discretized plate is replaced by a diagonal equivalent damping matrix. Each diagonal element represents an equivalent damper inserted between the structure and ground. In this method the numbe...
Citation Formats
K. Bilgin, “Predicition of static-torque characterisitcs of variabla reluctance multi-stack stepping motor.,” Middle East Technical University, 1980.
METU IIS - Integrated Information Service open@metu.edu.tr