A Wideband Fractal Antenna and Comparison of RF Rectifiers for Electromagnetic Energy Harvesting

2017-11-30
Ozdemir, Huriye
Nesimoglu, Tayfun
This paper presents a wideband fractal antenna and compares two efficient rectifier topologies suitable for 2.45 GHz band. The combined fractal antenna and the rectifiers may be used for ambient RF energy harvesting from wireless LAN/Wi-Ei. The proposed fractal antenna covers the most frequently encountered frequency bands which are located around 1800 MHz, 2.1 GHz, 2.4 GHz and 2.45 GHz corresponding to standards like GSM/DCS, UMTS, ISM and WLAN respectively. The return loss of the proposed antenna is below -10 dB and its gain is 4 dBi between 2.40-2.47 GHz. Two different Greinacher voltage tripler rectifier circuits were designed to compare the RF to DC conversion efficiency and power handling capability of the rectifying circuit structures. Up to 60% power efficiency was achieved with the proposed rectifiers at 2.45 GHz.
Mediterranean Microwave Symposium (MMS)

Suggestions

A Self-Powered Rectifier Circuit for Low-Voltage Energy Harvesting Applications
Ulusan, Hasan; Gharehbaghi, Kaveh; Zorlu, Ozge; Muhtaroglu, Ali; Külah, Haluk (2012-12-05)
This paper presents a fully self-powered low voltage and low power active rectifier circuit for vibration-based electromagnetic (EM) energy harvesters. A passive AC/DC doubler is used to provide a supply voltage for the active rectifier circuit. The proposed circuit is designed using standard 90 nm TSMC CMOS technology. The simulation results show that the proposed active rectifier circuit has voltage conversion ratio higher than 150% when the input peak voltage is more than 100 mV at open-load condition. T...
A Self-Powered and Efficient Rectifier for Electromagnetic Energy Harvesters
Ulusan, Hasan; Zorlu, Ozge; Muhtaroglu, Ali; Külah, Haluk (2014-11-05)
This paper presents an interface circuit for efficient rectification of voltages from electromagnetic (EM) energy harvesters operating with very low vibration frequencies. The interface utilizes a dual-rail AC/DC doubler which benefits from the full cycle of the input AC voltage, and minimizes the forward bias voltage drop with an active diode structure. The active diodes are powered through an AC/DC quadrupler with diode connected (passive) transistors. The interface system has been validated to drive 22 m...
A 180 nm Self-Powered Rectifier Circuit for Electromagnetic Energy Harvesters
Ulusan, Hasan; Zorlu, Ozge; Külah, Haluk; Muhtaroglu, Ali (2013-12-18)
This paper presents a new self-powered low voltage rectifier implementation for vibration-based electromagnetic (EM) energy harvesters. The proposed circuit is an improved version of the previously reported rectifier, which was designed in TSMC 90 nm CMOS technology. The circuit is designed in lower cost UMC 180 nm CMOS technology, and uses a passive AC/DC quadrupler structure to supply the external power of the utilized active components. Simulation results show that the maximum power conversion efficiency...
An efficient integrated interface electronics for electromagnetic energy harvesting from low voltage sources
Ulusan, Hasan; Gharehbaghi, Kaveh; Zorlu, Ozge; Muhtaroglu, Ali; Külah, Haluk (2013-12-01)
This paper presents a fully-integrated self-powered interface circuit for efficient rectification of the signals generated by vibration based low-voltage electromagnetic (EM) energy harvesters. The circuit utilizes an improved AC/DC doubler structure with active diodes to minimize the forward bias voltage drop for enhancing the rectifier efficiency. The comparators in the active diodes are powered internally by another passive AC/DC doubler with diode connected transistors. The performance is maximized thro...
A vibration-based electromagnetic energy harvester system with highly efficient interface electronics
Rahimi, Arian; Zorlu, Özge; Muhtaroǧlu, Ali; Külah, Haluk (2011-09-01)
This paper presents a vibration-based electromagnetic (EM) energy harvester system utilizing novel and highly efficient interface electronics. The energy harvesting module up-converts the environmental low frequency vibrations for increased AC power output. The interface circuit employs a boot-strap technique to reduce the threshold voltage of the rectifiers further increasing the power conversion efficiency of the overall system. The complete system, composed of an energy harvester module, and a compact 0....
Citation Formats
H. Ozdemir and T. Nesimoglu, “A Wideband Fractal Antenna and Comparison of RF Rectifiers for Electromagnetic Energy Harvesting,” Marseille, France, 2017, p. 0, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/65312.