POLYMERIZATION OF BIS(4-BROMO-2,6-DICHLOROPHENOXO) ETHYLENEDIAMINE COPPER(II) COMPLEX BY ELECTRO-INITIATION

1991-01-01
KISAKUREK, D
YIGIT, S
Bis(4-bromo-2,6-dichlorophenoxo) ethylenediamine copper(II) complex has been polymerized using electro-initiation by constant potential electrolysis, in dimethylformamide-tetrabutylammonium fluoroborate solvent-supporting electrolyte couple, at room temperature under air or N2. The process leads to low molecular weight (5.6 x 10(3)) linear poly(dichlorophenylene oxide). The structures of the polymers were determined by H-1-NMR and C-13-NMR. The kinetics of the polymerization were followed by in situ cyclic voltammetry measurements during electrolysis. Unlike thermal polymerization of this complex, the polymerization by electro-initiation begins immediately.
EUROPEAN POLYMER JOURNAL

Suggestions

ELECTRO-INITIATED POLYMERIZATION OF BIS-(2,4,6-TRIBROMOPHENOXO) ETHYLENEDIAMINE COPPER(II) COMPLEX IN DMF AND ITS KINETIC-STUDY BY CYCLIC VOLTAMMETRY
Toppare, Levent Kamil; YIGIT, S; KISAKUREK, D; Akbulut, Ural (Elsevier BV, 1990-01-01)
The decomposition of bis-(2,4,6-tribromophenoxo) ethylenediamine copper(II) complex in dimethylformamide by electro-oxidation yields low molecular weight (4.5 × 103) linear poly(dibromophenylene oxide). Electro-initiated polymerization was accomplished upon oxidation by a constant potential electrolysis under air or under N2 at room temperature. Polymerization conditions were based on the peak potentials measured by cyclic voltammetry. Constant peak potentials carried out at anodic and cathodic peak potenti...
Polymerization of propylene oxide by the Pruitt-Baggett catalyst
Çolak, Nureddin; Alyürük, Kemal (Elsevier BV, 1989-9)
The Pruitt-Baggett adduct (PBA) which formed from the reaction of FeCl3 with propylene oxide (PO) was hydrolysed in diethyl ether (ether) solutions at different mole ratios. Although the hydrolysates were insoluble in ether they could be converted into PO-soluble form (PBC) by a thermal treatment providing that the r value was kept smaller or equal to unity. PBC polymerized PO concurrently into a mixture of high molecular weight crystalline polymer with low molecular weight non-crystallizable oligomers. Th...
Electrochemical polymerisation of 2-aminofluorene in ethylalcohol/water medium
Imamoglu, T; Önal, Ahmet Muhtar (Elsevier BV, 2004-08-01)
Electrochemical polymerisation of 2-aminofluorene, 2AF, was investigated in ethylalcohol/water mixture (3:2, v:v) in the presence of HClO4 as the supporting electrolyte via constant potential electrolysis, CPE. Prior to CPE, electrochemical behaviour of the monomer was investigated in the same solvent electrolyte couple utilising cyclic voltammetry, CV. Electrochemical polymerisation of the monomer yielded insoluble, dark bluish-green, conducting polymer deposit on the electrode surface. Characterisation of...
POLYMETHYLALUMINIUM OXIDE AND STEREOREGULAR POLYMERIZATION OF PROPYLENE-OXIDE
OKTEM, Z; SARI, A; ALYURUK, K (Elsevier BV, 1993-05-01)
Polymethylaluminium oxide (PMAO) was prepared by reacting trimethylaluminium (AlMe3) with water in dilute dioxane solution. Several PMAO samples with different degrees of polymerizations (DP) were prepared (1 less-than-or-equal-to DP less-than-or-equal-to 7) either by changing reaction conditions or by fractionating the products. PMAO with DP about unity was found to be trimeric in dilute dioxane solutions but, in higher dielectric solvents, it partially dissociated into free ions. Electrical conductance me...
Immobilization of invertase and glucose oxidase in poly 2-methylbutyl-2-(3-thienyl) acetate/polypyrrole matrices
Isik, S; Alkan, S; Toppare, Levent Kamil; Cianga, I; Yagci, Y (Elsevier BV, 2003-12-01)
Immobilization of invertase and glucose oxidase in conducting polypyrrole and copolymers of poly 2-methylbutyl-2-(3-thienyl) acetate with pyrrole were achieved via electrochemical method. Sodium dodecyl sulphate was found to be the most suitable supporting electrolyte. Maximum reaction rate, Michaelis-Menten constant and optimum temperatures were determined for native and immobilized enzymes. Storage and operational stabilities of enzyme electrodes were also investigated.
Citation Formats
D. KISAKUREK and S. YIGIT, “POLYMERIZATION OF BIS(4-BROMO-2,6-DICHLOROPHENOXO) ETHYLENEDIAMINE COPPER(II) COMPLEX BY ELECTRO-INITIATION,” EUROPEAN POLYMER JOURNAL, pp. 955–958, 1991, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/65500.