Microcomputer control of linear motion of a lathe cutting tool.

Date

1983

Author

Dalgıç, Aykut

Metadata

Show full item record

Item Usage Stats

89
views

0
downloads

URI

https://hdl.handle.net/11511/7314

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

Microcomputer based differential relay. Taşdelen, Hürol; Department of Electrical and Electronics Engineering (1987)
microcomputer aided simulation of wind turbines by means of a thyristor controlled D.C.motor. Kocaoğlu, Mehmet; Department of Electrical Engineering (1986)
Micromachined silicon accelerometers and gyroscopes Najafi, K; Chae, JS; Külah, Haluk; He, GH (2003-01-01) This paper presents research at The University of Michigan on micromachined capacitive silicon accelerometers and gyroscopes with their interface electronics to satisfy the requirements for inertial navigation applications. The accelerometer systems developed employ in-plane (lateral), out-of-plane (z-axis), and single-chip 3-axis sensors with the interface electronics. The interface electronics forms a second-order electromechanical sigma-delta modulator together with the sensor and the system can be opera...
Micromachined accelerometers for inertial navigation applications Chae, Junseok; Külah, Haluk; Najafi, Khalil (2005-01-01) This paper presents research at The University of Michigan on micromachined accelerometers and their interface electronics to satisfy the requirements for inertial navigation applications. The accelerometer systems developed employ in-plane (lateral), out-of-plane (z-axis), and single-chip 3-axis sensors with the interface electronics. The interface electronics forms a second-order electromechanical sigma-delta modulator together with the sensor and the system can be operated in both open and closed-loop. T...
Microprocessor implementation of frequency control for wind energy conversion system. Güngördü, Bahadir; Department of Electrical Engineering (1986)

Citation Formats

A. Dalgıç, “Microcomputer control of linear motion of a lathe cutting tool.,” Middle East Technical University, 1983.