Single layer printed circuit board design

Download
002915.pdf
1987
Kendir, T Hürsel
Show full item record
108
views
0
downloads
https://hdl.handle.net/11511/7922
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Single layer graphene Hall sensors for scanning Hall probe microscopy (SHPM) in 3-300 K temperature range
Sonusen, S.; KARCI, ÖZGÜR; DEDE, MUNIR; Aksoy, S.; Oral, Ahmet (2014-07-30)
Graphene micro-Hall probes were developed for a scanning Hall probe microscope system and used for the direct magnetic imaging domains of demagnetized NdFeB permanent magnet for the first time. The Hall coefficient and minimum magnetic field resolution of graphene Hall probes at 1 kHz were found to be 0.18 Omega/G and 0.20 G/root Hz for a drive current of 3 mu A at room temperature in vacuum. The magnetic domains in NdFeB demagnetized magnet were observed at 300K, 126K and 3K successfully.
Single layer microbolometer detector pixel using ZnO material
TANRIKULU, MAHMUD YUSUF; Yildizak, Cigdem; Okyay, Ali K.; Akar, Orhan; Sarac, Adem; Akın, Tayfun (2018-04-19)
This paper presents the development of a single layer microbolometer pixel fabricated using only ZnO material coated with atomic layer deposition. Due to the stress-free nature and high temperature coefficient of resistance of the ALD coated ZnO material, it can be used both as structural and active layers in microbolometer detectors. The design, simulations, and the fabrication optimization of 35. m single layer ZnO microbolometers are shown in this study. The designed pixel has a thermal conductance of 3....
Single Step Inverted Pyramid Texturing of n-type Silicon by Copper Assisted Chemical Etching
Altinsoy, Busra; Donercark, Ergi; Aliefendioglu, Atescan; Turan, Raşit (2021-01-01)
In this paper, we present the results of the study on the fabrication of inverted pyramids on n-type Si wafer by a single-step anisotropic copper-assisted chemical etching. The relationship between etchant composition, etching time and the surface morphology for n-type Si has been investigated. Different surface structures were obtained by adjusting molarity of H2O2, Cu(NO3)(2), HF in the etching solution. Cu(NO3)(2) amount promoted, while increasing H2O2 amount over optimum value reduced the etch rate. By ...
Two layers substrate integrated waveguide power divider
Mohammadi, Pejman; Demir, Şimşek (2011-11-21)
In this paper a novel two layers power divider based on Substrate Integrated Waveguide (SIW) is proposed. It includes two layers of SIW with a slot in each layer. The electromagnetic wave is coupled from lower layer to upper layer through slot. The electrical performance including return loss and transmission characteristic are presented. Simulation shows the return loss about -16dB and insertion loss about -3.6dB at 10 GHz. This SIW power divider is fabricated and measured. Due to some problems the measure...
Single phase distribution systems.
Uçan, Bahadir; Department of Electrical Engineering (1985)
Citation Formats
T. H. Kendir, “Single layer printed circuit board design,” Middle East Technical University, 1987.
METU IIS - Integrated Information Service open@metu.edu.tr