Determination of the experiment sample size in electric discharge machining.

1983
Darendeliler, Haluk
Show full item record
152
views
0
downloads
https://hdl.handle.net/11511/7943
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Determination of jet energy calibration and transverse momentum resolution in CMS
Chatrchyan, S.; et. al. (IOP Publishing, 2011-11-01)
Measurements of the jet energy calibration and transverse momentum resolution in CMS are presented, performed with a data sample collected in proton-proton collisions at a centre-of-mass energy of 7TeV, corresponding to an integrated luminosity of 36p(-1). The transverse momentum balance in dijet and gamma/Z+jets events is used to measure the jet energy response in the CMS detector, as well as the transverse momentum resolution. The results are presented for three different methods to reconstruct jets: a ca...
Determination of the whiteness appearance of the crystal sugars by visual appearance and reflectance measurements methods.
Çürük, Vehbi; Department of Chemistry (1981)
Determination of Displacement Amplification Factors for Chevron BRBFs
Bozkurt, Mehmet Bakır; Özkılıç, Yasin Onuralp; Topkaya, Cem (null; 2017-10-05)
Buckling restrained braced frames (BRBFs) can be used as a lateral load resisting system in high seismic regions. In the United States it is necessary to comply with the requirements defined in the Seismic Provisions for Structural Steel Buildings (AISC341- 10) for the design and production of BRBs. In addition, response factors defined in Minimum Design Loads for Buildings and Other Structures (ASCE 7-10) should be utilized. In this study, deflection amplification factor (Cd) is evaluated. Pursuant to this...
Determination of out-of-step blockibg conditions in high voltage networks.
Atabay, Tarhan M H; Department of Electrical Engineering (1973)
Determination of obsidian hydration diffusion coefficient.
Dereli, Gülay; Department of Physics (1978)
Citation Formats
H. Darendeliler, “Determination of the experiment sample size in electric discharge machining.,” Middle East Technical University, 1983.
METU IIS - Integrated Information Service open@metu.edu.tr