Experimental Investigation of Transformation Plasticity of SAE 52100 Bearing Steel

Date

2014-01-01

Author

Şimşir, Caner
Davut, Kemal
Gür, Cemil Hakan

Metadata

Show full item record

Item Usage Stats

58
views

0
downloads

URI

https://hdl.handle.net/11511/81988

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Experimental investigation of dynamic delamination in curved composite laminates Uyar, İmren; Çöker, Demirkan; Department of Aerospace Engineering (2014) In the aerospace industry, high demand for lightweight structures is fostering the use of composite laminates in a wide variety of shapes, as primary load carrying elements. However, once a composite laminate takes a highly curved shape, such as an L-shape, high interlaminar stresses induced in the curved region causes dynamic delamination formation. This thesis discusses the experimental investigation of delamination in L-shaped CFRP composite laminates under quasi-static shear loading. An experimental set...
Experimental investigation for mechanical properties of filament wound composite tubes Erdiller, Emrah Salim; Parnas, Kemal Levend; Department of Mechanical Engineering (2004)
Experimental investigation of effects of cutting parameters on surface roughness in wedm process Ozanözgü, Alp Mithat; Gökler, Mustafa İlhan; Department of Mechanical Engineering (1998)
Experimental Investigation of Thermal Performance of a Silicon Flat Plate Grooved Heat Pipe with an integrated heater and cooler Kurt, Cem; Alijani, Hossein; Çetin, Barbaros; Akkuş, Yiğit; Dursunkaya, Zafer (2018-06-13)
Experimental Investigation of Crack Propagation Mechanisms in Commercially Pure Aluminium Plates Tekoğlu, C.; Çelik, Ş.; Duran, H.; Efe, M.; Nielsen, K.L. (Elsevier BV; 2019) The crack surface morphology in tearing of ductile metal plates depends on the mechanical properties, chemical composition and the microstructure of the plate material as well as on the loading conditions and the specimen geometry. This study assesses the crack surface morphologies observed in commercially pure aluminium plates (Al 1050 H14). Mode I tearing was performed in both single and double edge notched tensile test setups with specimens cut from five different plates with different thickness t, viz. ...

Citation Formats

C. Şimşir, K. Davut, and C. H. Gür, “Experimental Investigation of Transformation Plasticity of SAE 52100 Bearing Steel,” 2014, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/81988.