Experimental investigation on turbulent forced convection in pipes-constant wall temperature case

Download
035567.pdf
1994
Akay, Hasan Sinan
Show full item record
123
views
0
downloads
https://hdl.handle.net/11511/9604
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Experimental investigation on upward forced convection in vertical pipes with constant surface temperature
Özyurt, Ercüment; Oskay, Rüknettin; Department of Mechanical Engineering (1999)
EXPERIMENTAL INVESTIGATION OF THE EFFECTS OF WAVEFORM TIP INJECTION IN A LOW PRESSURE TURBINE CASCADE
Mercan, Bayram; Dogan, Eda; Ostovan, Yashar; Uzol, Oğuz (2012-06-15)
This paper presents the results of an experimental study that investigates the effects of uniform/waveform tip injection along the camberline on the total pressure loss and wake flow characteristics downstream of a row of Low Pressure Turbine (LPT) blades. The experiments are performed in a low speed cascade facility. This injection technique involves spanwise jets at the tip that are issued from a series of holes along the camber line normal to the freestream flow direction. The injection mass flow rate fr...
Experimental investigation of waveform tip injection on the characteristics of the tip vortex
Ostovan, Yashar; Uzol, Oğuz; Department of Aerospace Engineering (2011)
This study investigates the effect of chordwisely modulated tip injection on the flow and turbulence characteristics of the tip vortex through experimental measurements downstream of a rectangular half-wing that has an aspect ratio of three. This injection technique involves spanwise jets at the tip that are issued from a series of holes along the chord line normal to the freestream flow direction. The injection mass flow rate from each hole is individually controlled using computer driven solenoid valves a...
Experimental investigation of flow separation from rigid walls with salient edges
Akçalı, Fikri; Alemdaroğlu, Hüseyin Nafiz; Department of Aerospace Engineering (2004)
This thesis presents the experimental results on the formation of flow separation from a rigid wall with a salient edge. In the case of automotive vehicles or aircrafts with rear cargo compartment doors, such salient edges are at the origin of separated wake flows resulting in increased drag and other disturbing effects. Recent studies of Ahmed et al. (1984) on simplified geometries showed the strong influence of the slant angle on the flow separations. In this study, the geometry is further simplified to e...
Experimental Investigation of Eccentric Reinforced Concrete Beam-Column-Slab Connections under Earthquake Loading
Burak Bakır, Burcu (2004-08-01)
The inelastic behavior of beam-to-column joints has been studied since 1960’s; however, there is still limited information on eccentric connections, in which the centerline of the spandrel beam does not coincide with the centroid of the column. In this experimental study, the seismic behavior of three 3/4- scale eccentric beam-column-slab subassemblies was investigated. The main design parameters were selected as the eccentricity, normal beam width, and column section aspect ratio. The eccentricity between ...
Citation Formats
H. S. Akay, “Experimental investigation on turbulent forced convection in pipes-constant wall temperature case,” Middle East Technical University, 1994.
METU IIS - Integrated Information Service open@metu.edu.tr