Design of automatic tool changer for CNC machines

Download
047311.pdf
1995
Koç, Murat Bilgin
Show full item record
270
views
0
downloads
https://hdl.handle.net/11511/10045
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design of magneto-electric dipole antenna for wideband communication systems
Alparslan, Semih; Alatan, Lale; Department of Electrical and Electronics Engineering (2018)
This thesis includes the design, simulation, production and measurement of a differential fed magneto-electric dipole antenna with cavity operating at ultrawideband (3.3 GHz – 10 GHz). This antenna consists of a differential feeding structure, an electric dipole, a magnetic dipole and a cavity. The ultra-wideband operation is achieved through the use of differential feeding structure and cavity. A step-by-step procedure is followed during the design process of the differential fed magneto-electric dipole an...
Design of Fuel Cell and Electrolyzer Emulators for Photovoltaic Applications
Koubaa, Ahmed; Krichen, Lotfi; Ouali, Abderrazak (2011-09-10)
This paper focuses on the design of fuel cell and electrolyzer emulators used for photovoltaic applications. These emulators are based on power electronic circuits. The reference values of the two emulators are taken from fuel cell and electrolyzer mathematical models. In this study, proportional integral regulators are used. A power management is established to ensure a balance between production and consumption. The simulation results show the good performances of the two emulators to produce the electric...
Design of smart controllers for hybrid electric vehicles
Özen, Ekin; Dölen, Melik; Department of Mechanical Engineering (2005)
This thesis focuses on the feasibility of designing a commercial hybrid electric vehicle (HEV). In this work, relevant system models are developed for the vehicle including powertrain, braking system, electrical machines and battery. Based on these models ten different HEV configurations are assembled for detailed assessment of fuel consumption. This thesis also proposes a smart power management strategy which could be applied to any kind of HEV configuration. The suggested expert system deals with the exte...
Design of selective linear phase cross-coupled dielectric resonator filters
Öztürk, Onur Ozan; Dural Ünver, Mevlüde Gülbin; Yıldırım, Nevzat; Department of Electrical and Electronics Engineering (2018)
In this work, a selective linear phase filter is designed in cross-coupled form using dielectric resonators in Ku band to be used as a channel filter in IMUX of a satellite receiver. Extreme delay flatness is required: 1.5ns delay ripple over 60 % of the passband and symmetric cross-coupled filter with all ideal inverter couplings realizing four finite transmission zeros (FTZ) satisfying also the delay flatness requirements. Design is carried out on the software program FILPRO, then optimized in ADSTM and t...
Design of Selective Linear Phase Cross-Coupled Dielectric Resonator Filters
Ozturk, Onur Ozan; Oruc, Sacid; Alicioglu, Bulent; Yıldırım, Nevzat (2018-11-02)
In this paper, a highly selective linear phase filter is designed and implemented in cross-coupled form using dielectric resonators in Ku band to be used as a channel filter in IMUX of a satellite receiver. Extreme delay flatness is required: 1.5 nS delay ripple over 60 % of the passband and 12 nS near the band edges. The initial design is carried out as 10 resonator symmetric cross-coupled filter with all ideal inverter couplings realizing two finite transmission zeros (FTZ) satisfying also the delay flatn...
Citation Formats
M. B. Koç, “Design of automatic tool changer for CNC machines,” Middle East Technical University, 1995.
METU IIS - Integrated Information Service open@metu.edu.tr