Mechanical properties of graft copolymers of polypyrrole

2001
Biran, Canan
Show full item record
111
views
0
downloads
https://hdl.handle.net/11511/10842
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Mechanical properties of conducting H-type polysiloxane-polypyrrole graft copolymers and polytetrahydrofuran-polypyrrole block copolymers
Biran, C; Toppare, Levent Kamil; Tincer, T; Yagci, Y; Harabagiu, V (2002-11-14)
The mechanical properties of block copolymers of polypyrrole and pyrrolyl-ended azobis-polytetrahydrofuran (TPPy) and graft copolymers of pyrrolyl-ended H-type polydimethylsiloxane (SPPy) were investigated and compared with those of polypyrrole (PPy), Conducting films were prepared electrochemically at a constant potential and doped with p-toluene sulfonate. (C) 2002 Wiley Periodicals, Inc.
Mechanical Properties of 3D-Printed Elastomeric Foams
Bakır, Ali Alperen; Özerinç, Sezer (2020-11-27)
Mechanical properties of unsaturated polyester/montmorillonite composites
Inceoglu, AB; Yılmazer, Ülkü (2001-11-29)
Nanocomposites composed of unsaturated polyester matrix and organically modified clay filler were prepared. After the synthesis, XRD patterns showed that the interlayer spacing expanded from 1.25 nm to 4.5 nm. The mechanical properties of the nanocomposites were determined and it was found that adding only 3 w/w % organically modified clay improved the flexural modulus of unsaturated polyester by 35%. From DSC diagrams, it was found that T-g values of the nanocomposites also increased with the clay content....
Mechanical Performance of Resol Type Phenolic Resin/Layered Silicate Nanocomposites
Tasan, C. Cem; Kaynak, Cevdet (Wiley, 2009-03-01)
Clay addition has been shown to affect polymer resins positively in terms of several physical and chemical properties, including mechanical performance, high temperature endurance and durability. These increases are limited only to relatively low concentrations of reinforcement phase, but at these low concentrations polymer/layered silicate nanocomposites (P/LS NC) have shown to exhibit higher mechanical performance than fiber reinforced polymer composites. This is among the several reasons that make P/LS N...
Mechanical properties of poylmer/bioceramics based 3D porous scaffolds in hard tissue engineering
Evis, Zafer (2018-11-09)
Citation Formats
C. Biran, “Mechanical properties of graft copolymers of polypyrrole,” Middle East Technical University, 2001.
METU IIS - Integrated Information Service open@metu.edu.tr