Design and implementation of micro controller based electronic weighing and bagging machine

Download
035461.pdf
1994
Koruk, Erhan
Show full item record
79
views
0
downloads
https://hdl.handle.net/11511/10956
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design and implementation of power quality monitoring system for distribution systems
Toka, Nadire Arzu; Bazlamaçcı, Cüneyt Fehmi; Department of Electrical and Electronics Engineering (2019)
Smart grid concept is a significantly important topic all over the world. The consumers should be supplied with power sources that is as clean as possible. The quality of delivered power depends on parameters defined in various standards such as The Electrical Distribution System Supply Reliability and Quality of Electricity Regulation in Turkey. To achieve complete control on the grid, Power Quality (PQ) should be monitored and controlled at the end of the distribution system. Considering the number of the...
Design and experimental investigation of microchannel heat exchanger
Çetin, Murat; Güvenç Yazıcıoğlu, Almıla; Department of Mechanical Engineering (2010)
Due to the high performance of electronic components, the heat generation is increasing dramatically. Heat dissipation becomes a significant issue in efficiency promotion and stable operation. Microchannels are of current interest for use in heat exchangers where very high heat transfer performance is desired. Microchannels provide high heat transfer coefficients because of their small hydraulic diameters. In this study, the design and experimental investigation of fluid flow and heat transfer in a microcha...
Design and implementation of 200 joule/second capacitor charging power supply and flashtube driving system
Erentürk, Birol; Çadırcı, Işık; Department of Electrical and Electronics Engineering (1995)
Design and implementation of low power interface electronics for vibration-based electromagnetic energy harvesters
Rahimi, Arian; Külah, Haluk; Muhtaroğlu, Ali; Department of Electrical and Electronics Engineering (2011)
For many years batteries have been used as the main power sources for portable electronic devices. However, the rate of scaling in integrated circuits and micro-electro-mechanical systems (MEMS) has been much higher than that of the batteries technology. Therefore, a need to replace these temporary energy reservoirs with small sized continuously charged energy supply units has emerged. These units, named as energy harvesters, use several types of ambient energy sources such as heat, light, and vibration to ...
Design and implementation of low phase noise phase locked loop based local oscillator
Bölücek, Muhsin Alperen; Yıldırım, Nevzat; Department of Electrical and Electronics Engineering (2009)
In this thesis, a low phase noise local oscillator operating at 2210 MHz is designed and implemented to be used in X-Band transmitter of a LEO satellite. Designed local oscillator is a PLL (Phase Locked Loop) based frequency synthesizer which is implemented using discrete commercial components including ultra low noise voltage controlled oscillator and high resolution, low noise fractional-N synthesizer. Operational settings of the synthesizer are done using three wire serial interface of a microcontroller....
Citation Formats
E. Koruk, “Design and implementation of micro controller based electronic weighing and bagging machine,” Middle East Technical University, 1994.
METU IIS - Integrated Information Service open@metu.edu.tr