Microstructural identification of partially stereoregular poly (propylene oxide).

1985
Uğur, Nazan

Suggestions

Living radical polymerization of hydroxyethyl methacrylate and its block copolymerization with poly(dimethyl siloxane) macroazoinitiator
Vargün, Elif; Usanmaz, Ali; Department of Polymer Science and Technology (2009)
Hydrophilic poly(2-hydroxyethyl methacrylate), PHEMA, and hydrophobic poly(dimethyl siloxane), PDMS, segments containing copolymers have been widely used as a biomaterial. These amphiphilic copolymers also used as an emulsifying agent in polymer solutions and compatibilizer in polymer blends. In this case, solution polymerizations of HEMA by radiation, ATRP and RAFT methods were studied. The thermal degradation mechanism of PHEMA, which was prepared in aqueous solution by gamma radiation technique, was stud...
Laminar filmwise condensation of flowing vapor on a sphere
Erol, Doğuş; Yamalı, Cemil; Department of Mechanical Engineering (2004)
The objective of this study is to analyze theoretically the laminar film condensation of water vapor flowing on a sphere. For this purpose, the problem was handled by including all of the two-phase boundary layer parameters such as gravity, effect of vapor shear, inertia, energy convection and pressure gradient. For this full two-phase boundary layer system, the boundary layer equations, boundary conditions and the interfacial conditions were first analyzed, and then discretized. A computer program in Mathc...
Shape Optimization of Reentry Vehicles to Minimize Heat Loading
Eyi, Sinan; Boyd, I D (2019-01-06)
The objective of the current study is to design an optimum reentry vehicle shape that minimizes heat loading subject to constraints on the maximum values of surface heat flux and temperature. A new heat loading formulation is developed for objective function evaluations. Axisymmetric Navier-Stokes and finite-rate chemical reaction equations are solved to evaluate the objective and constraint functions. The Menter SST turbulence model is employed for turbulence closure. A gradient-based method is used for op...
Immobilization of tyrosinase in polysiloxane/polypyrrole copolymer matrices
Arslan, Ahu; Toppare, Levent Kamil; Department of Chemistry (2006)
Immobilization of tyrosinase in conducting copolymer matrices of pyrrole functionalized polydimethylsiloxane/polypyrrole (PDMS/PPy) were achieved by electrochemical polymerization. The polysiloxane/polypyrrole/tyrosinase electrode was constructed by the entrapment of enzyme in conducting matrices during electrochemical copolymerization. Maximum reaction rate (Vmax) and Michaelis-Menten constant (Km) were investigated for immobilized enzyme. Enzyme electrodes were prepared in two different electrolyte/solven...
Energy analysis of a solar assisted absorption heat pump for floor heating system
Sarı, Özgür Gökmen; Yamalı, Cemil; Department of Mechanical Engineering (2004)
Solar assisted single-stage absorption heat pump (AHP) was used to supply energy to a floor-heating system by using the exergy methods. An existing duplex-house,in Ankara, with a heating load of 25.5 kW was analysed. Heating loads of the spaces in the building were calculated and a floor heating panel was modelled for each space leading to the capacity of the AHP before it was designed. Solar energy was delivered to the evaporator and high temperature heat input delivered to the genarator are met by auxilia...
Citation Formats
N. Uğur, “Microstructural identification of partially stereoregular poly (propylene oxide).,” Ph.D. - Doctoral Program, Middle East Technical University, 1985.