Design and implementation of a microprocessor controlled switched reluctance motor drive

Download
029579.pdf
1993
Safavi, Amir
Show full item record
173
views
0
downloads
https://hdl.handle.net/11511/11848
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design and implementation of a fixed point digital active noise controller headphone
Erkan, Fatih; Çiloğlu, Tolga; Department of Electrical and Electronics Engineering (2009)
In this thesis, the design and implementation of a Portable Feedback Active Noise Controller Headphone System, which is based on Texas Instruments TMS320VC5416PGE120 Fixed Point DSP, is described. Problems resulted from fixed-point implementation of LMS algorithm and delays existing in digital ANC implementation are determined. Effective solutions to overcome the aforementioned problems are proposed based on the literature survey. Design of the DSP based control card is explained and crucial points about an...
Design and implementation of an optimized printed circuit board axial-flux permanent magnet machine
Tokgöz, Furkan; Çakal, Gökhan; Keysan, Ozan (2020-08-23)
© 2020 IEEE.Although axial-flux machines are used in a different variety of applications, production challenge of the stator winding is a limiting factor for more widely use of these machines. Printed circuit board winding (PCB) can mitigate the production challenges of the axial-flux machines by introducing cheap and precise mass production capabilities. In this paper, the design and implementation of an 16 pole, 2000 RPM, 40 W axial-flux permanent magnet machine with PCB winding for gimbal camera stabiliz...
Design and implementation of a microcontroller based radio modem
Muşabak, Cem; Bulut, M. Mete; Department of Electrical and Electronics Engineering (1997)
Design and implementation of an annular acoustic levitation system
Kandemir, Mehmet Hakan; Çalışkan, Mehmet; Department of Mechanical Engineering (2014)
In standing wave acoustic levitation technique, a standing wave is obtained between a source and a reflector. Particles can be attracted towards pressure nodes in standing waves owing to the spring action. Hence, particles can be suspended in air. This operation can be performed on continuous structures as well as in several numbers of axes. In this study an annular acoustic levitation set-up is designed and built. The set-up consists of two langevin type piezoelectric transducers, two waveguides, an annula...
Design and implementation of a low emittance high power thermionic DC electron gun
Sezer, Mustafa; Güler, Ali Murat; Department of Physics (2021-2-8)
In this thesis, a thermionic electron gun generating low emittance and the high power electron beam is designed. The thermionic cathode made of a LaB6 single crystal is chosen as a thermionic emitter because of its properties ensuring high electron beam current in lower temperatures which provide lower emittance. The main goal of the gun design is to achieve a high DC beam current and low emittance. Computer Sim- ulation Technology (CST) and MATLAB are used to design the gun and optimize electrode shapes an...
Citation Formats
A. Safavi, “Design and implementation of a microprocessor controlled switched reluctance motor drive,” Middle East Technical University, 1993.
METU IIS - Integrated Information Service open@metu.edu.tr