Design and implementation of front-end electronics for an infrared imagingh system

Download
116445.pdf
2001
Yeler, Abdülkadir
Show full item record
72
views
269
downloads
https://hdl.handle.net/11511/12273
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design and implementation of post processing unit for an intertial nevigation system
Orhan, M. Naci; Demirbaş, Kerim; Eren, Murat; Department of Electrical and Electronics Engineering (1996)
Design and construction of a coating reactor for R.F. thermal plasma system
Yıldırım, Hatice Gözde; Öztürk, Tayfur; Department of Metallurgical and Materials Engineering (2017)
Thermal plasma is a common method of surface coatings applied in a number of applications; aerospace, automotive and medical. Among them, medical application is probably the most critical as the coating should satisfy a number of requirements. Although D.C. plasma is the most common method used in coatings in general, R.F. plasma has its advantages, namely an extremely clean deposition condition as no electrode is involved in the process. In this study, a coating reactor was designed and constructed which c...
Design and implementation of a fixed point digital active noise controller headphone
Erkan, Fatih; Çiloğlu, Tolga; Department of Electrical and Electronics Engineering (2009)
In this thesis, the design and implementation of a Portable Feedback Active Noise Controller Headphone System, which is based on Texas Instruments TMS320VC5416PGE120 Fixed Point DSP, is described. Problems resulted from fixed-point implementation of LMS algorithm and delays existing in digital ANC implementation are determined. Effective solutions to overcome the aforementioned problems are proposed based on the literature survey. Design of the DSP based control card is explained and crucial points about an...
Design and fabrication of a high gain, broadband microwave limiting amplifier module
Kılıç, Hasan Hüseyin; Demir, Şimşek; Department of Electrical and Electronics Engineering (2011)
Microwave limiting amplifiers are the key components of Instantaneous Frequency Measurement (IFM) systems. Limiting amplifiers provide constant output power level in a wide input dynamic range and over a broad frequency band. Moreover, limiting amplifiers are high gain devices that are used to bring very low input power levels to a constant output power level. Besides, limiting amplifiers are required to provide minimum small signal gain ripple in order not to reduce the sensitivity of the IFM system over t...
Design and implementation of control unit of an inertial nevigation system
Hazır, sefa; Demirbaş, Kerim; Eren, Murat; Department of Electrical and Electronics Engineering (1996)
Citation Formats
A. Yeler, “Design and implementation of front-end electronics for an infrared imagingh system,” Middle East Technical University, 2001.
METU IIS - Integrated Information Service open@metu.edu.tr