Design and implementation of post processing unit for an intertial nevigation system

Download
056855.pdf
1996
Orhan, M. Naci
Show full item record
76
views
0
downloads
https://hdl.handle.net/11511/11168
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design and implementation of control unit of an inertial nevigation system
Hazır, sefa; Demirbaş, Kerim; Eren, Murat; Department of Electrical and Electronics Engineering (1996)
Design and implementation of a fixed point digital active noise controller headphone
Erkan, Fatih; Çiloğlu, Tolga; Department of Electrical and Electronics Engineering (2009)
In this thesis, the design and implementation of a Portable Feedback Active Noise Controller Headphone System, which is based on Texas Instruments TMS320VC5416PGE120 Fixed Point DSP, is described. Problems resulted from fixed-point implementation of LMS algorithm and delays existing in digital ANC implementation are determined. Effective solutions to overcome the aforementioned problems are proposed based on the literature survey. Design of the DSP based control card is explained and crucial points about an...
Design and implementation of an annular acoustic levitation system
Kandemir, Mehmet Hakan; Çalışkan, Mehmet; Department of Mechanical Engineering (2014)
In standing wave acoustic levitation technique, a standing wave is obtained between a source and a reflector. Particles can be attracted towards pressure nodes in standing waves owing to the spring action. Hence, particles can be suspended in air. This operation can be performed on continuous structures as well as in several numbers of axes. In this study an annular acoustic levitation set-up is designed and built. The set-up consists of two langevin type piezoelectric transducers, two waveguides, an annula...
Design and implementation of a microcontroller based radio modem
Muşabak, Cem; Bulut, M. Mete; Department of Electrical and Electronics Engineering (1997)
DESIGN AND IMPLEMENTATION OF HIGH FILL-FACTOR STRUCTURES FOR LOW-COST CMOS MICROBOLOMETERS
Erturk, Ozan; Akın, Tayfun (2018-01-25)
This paper reports utilization of high-fill factor absorber structures integrated onto SOI diode type low-cost uncooled microbolometers for broadband absorption performance. Mechanical and optical simulations are performed to assess the enhancement and mechanical stability of the absorber structures. Reported first time in the literature, four types of different absorber structures are employed on the same detector focal plane array (FPA) in order to evaluate the improvement provided by different absorber s...
Citation Formats
M. N. Orhan, “Design and implementation of post processing unit for an intertial nevigation system,” Middle East Technical University, 1996.
METU IIS - Integrated Information Service open@metu.edu.tr