An investigation into the cutting tools used in CNC machines

Download
075897.pdf
1998
Taşgın, T. Tolga
Show full item record
128
views
0
downloads
https://hdl.handle.net/11511/1645
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

An investigation into the loading of parts into an FMS with cyclic schedules
Özlü, Sinan; Kılıç, S. Engin; Department of Mechanical Engineering (1998)
An Investigation on the areas and locations of sunlight patches in patient rooms
Tanrıöver, Sezin; Düzgüneş, Arda; Department of Building Science in Architecture (2006)
Explored in this study were the patterns of direct sunlight received by differentlyoriented patient rooms in healthcare facilities. Desktop Radiance 1.02® software was used to simulate conditions in a typical double patient room. The area and locations of sunlight patches on room surfaces were considered as analog indicators for the investigation. The setting was defined as Ankara, Turkey. Seven orientations and 3 positions of standard-size window openings were studied in different combinations at solstices...
An investigation into friction induced noise
Kaval, Mustafa; Akkök, Metin; Çalışkan, Mehmet; Department of Mechanical Engineering (1989)
An investigation into power and energy requirements for the auxiliary components of a CNC lathe
Uluer, Muhtar Ural; Akkök, Metin (null; 2016-07-12)
An investigation on the performance optimization of an alkaline fuel cell
Ergul, MT; Turker, L; Eroğlu, İnci (1997-10-01)
A fuel cell test module was designed and constructed to determine the performance of an alkaline fuel cell. The sim was to optimize its performance by changing some of its parameters and to integrate it with a hydrogen photobioreactor in future. The fuel cell was a single cell, hydrogen-oxygen, aqueous electrolyte type. The performance characteristics of the cell have been investigated. The electrodes were multilayer Teflon bonded gas diffusion type and were prepared by the rolling method. Active carbon or ...
Citation Formats
T. T. Taşgın, “An investigation into the cutting tools used in CNC machines,” Middle East Technical University, 1998.
METU IIS - Integrated Information Service open@metu.edu.tr