Effects of bar cut off on shear behavior of reinforced concrete beams

Kazanç, Hakan


Effects of bar cutoff on flexural behavior of reinforced concrete beams
Acar, Fikri; Tankut, Tuğrul; Department of Civil Engineering (1997)
Effects of cast-in-place concrete topping on flexural response of precast concrete hollow-core slabs
Baran, Eray (2015-09-01)
Results of a study focusing on the flexural response of precast prestressed concrete hollow-core slabs with cast-in-place concrete topping are presented. The experimental part of the study included load testing of five precast concrete hollow-core units. The numerically determined flexural response of test specimens was later compared with the experimentally obtained behavior. Results demonstrate that a major composite action is valid between the hollow-core unit and the topping slab under load levels corre...
Effects of camberwise varying tip injection on loss and wake characteristics of a low pressure turbine blade
Mercan, Bayram; Dogan, Eda; Ostovan, Yashar; Uzol, Oğuz (2015-08-01)
This paper presents the results of an experimental study that investigates the effects of camberwise varying tip injection on the total pressure loss and wake flow characteristics downstream of a row of Low Pressure Turbine (LPT) blades. This injection technique involves spanwise jets at the tip that are issued from a series of holes distributed along the camber line. The injection from each hole is individually and separately controlled using a computer driven solenoid valve and therefore the flow injectio...
Effects of roughness on hydraulic jump properties
Birol, Bulent; Göğüş, Mustafa; Department of Civil Engineering (1989)
Effects of resterilization on mechanical properties of polypropylene meshes
Serbetci, Kemal; Kulacoglu, Hakan; Devay, Ali Onder; Hasırcı, Nesrin (2007-09-01)
Background: The re-use of sterile packaged polypropylene meshes in hernia surgery is not recommended by the manufacturers. However, especially in developing and underdeveloped countries, many surgeons are obliged to re-use the mesh pieces after resterilization because of economic problems. The purpose of this study was to determine the effects of ethylene oxide and autoclave resterilization on the mechanical properties of polypropylene meshes.
Citation Formats
H. Kazanç, “Effects of bar cut off on shear behavior of reinforced concrete beams,” Middle East Technical University, 1998.