A Study on geometric dimensioning and tolerancing

Download
082440.pdf
1999
Karabay, Macit
Show full item record
121
views
0
downloads
Engineering drawing, Tolerance (Engineering)
https://hdl.handle.net/11511/2505
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Experimental analysis of curved laminated beam
Uzhan, Tevfik; Aşık, Mehmet Zülfü; Department of Engineering Sciences (2010)
In this thesis, experimental studies are carried out on curved laminated glass beams to form a database for the scientists who may like to test their mathematical models. Beams which are only free to rotate and constrained in radial direction at both ends are tested to make the data available for further calculations. Test setup is prepared to minimize error that could occur due to test setup and data readings. Material testing machine and 4 channel data collecting machine are used to measure the signals at...
A model study on the effects of wall stiffness and surcharge on dynamic lateral earth pressures
Çilingir, Ulaş; Özkan, M. Yener; Department of Civil Engineering (2005)
A model study on laterally braced sheet pile walls retaining cohesionless soil was conducted using 1-g shaking table. Lateral dynamic earth pressures, backfill accelerations and dynamic displacement of walls were measured. Input accelerations were kept between 0.03g to 0.27g. A data acquisition system consisting of dynamic pressure transducers, accelerometers, displacement transducer, signal conditioning board and a data acquisition card compatible with a personal computer was used during the study. Three d...
A NOTE ON PETERLINS FORMULATION OF CASE-II DIFFUSION
Yılmaz, Levent (Wiley, 1982-01-01)
A High Performance PWM Algorithm for Common Mode Voltage Reduction in Three-phase Voltage Source Inverters
Uen, Emre; Hava, Ahmet Masum (2008-06-19)
A high performance PWM algorithm with reduced common mode voltage (CMV) and satisfactory overall performance is proposed for three-phase PWM inverter drives. The algorithm combines the near state PWM (NSPWM) method which has superior overall performance characteristics at high modulation index and MAZSPWM, a modified form of the active zero state PWM method (AZSPWM1), which is suitable for low modulation index range of operation. Since AZSPWM1 has line-to-line voltage pulse reversals with small zero-voltage...
Estimation of probability of failure for stepped path sliding with three joint sets
Korgan, H; Ozgenoglu, O (1999-08-28)
In jointed rock masses, sliding along a stepped path surface formed by two or more joint sets and sometimes shearing through the intact rock portion between the joints, is much likely to occur than sliding along single continuous surface. Although it has been focused on the two-joint set (i.e. one major and one cross joint set) stepped path sliding problem, there is little work on the analysis of stepped path sliding with three joint sets. In this paper, a simulation model developed for the analysis of step...
Citation Formats
M. Karabay, “A Study on geometric dimensioning and tolerancing,” Ph.D. - Doctoral Program, Middle East Technical University, 1999.
METU IIS - Integrated Information Service open@metu.edu.tr