Application of vapex process for light crude oil

Date

2008-01-01

Author

Kök, Mustafa Verşan
Akın, Serhat

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

243
views

0
downloads

The objective of this study is to investigate the applicability of Vapex process on Garzan crude oil. Experiments were performed with Hele-Shaw cell using two different solvents (propane and butane) at three different injection rates (20,40, and 80ml/min). For both Vapex solvents, oil production rates increased with injection rates for Garzan crude oil. Instantaneous asphaltene rate for Garzan oil showed fluctuated performance with propane solvent. Butane showed almost constant degree of asphaltene precipitation. For asphaltene precipitation, propane gave better results than butane in almost all injection rates for Garzan crude oil.

Subject Keywords

Fuel Technology, Renewable Energy, Sustainability and the Environment, Energy Engineering and Power Technology, Nuclear Energy and Engineering

URI

https://hdl.handle.net/11511/41254

Journal

ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS

DOI

https://doi.org/10.1080/15567030601100589

Collections

Department of Petroleum and Natural Gas Engineering, Article

Suggestions

OpenMETU
Core

Economical Evaluation of an Oil Field Reservoir Kök, Mustafa Verşan (Informa UK Limited, 2011-01-01) In this study, economical evaluation of an oil field reservoir was performed using software. The software used in this study consists of different sub-programs to determine recoverable oil, recovery factor, initial and final productions, production rates, and original oil and gas in place for different types of reservoirs. Recovery efficiency was found to be 29% for water drive and 4.78% for solution gas drive reservoirs. In decline curve analysis, initial and final production rates were obtained as 40 and ...
Application of vapour extraction VAPEX process for light crude oil Kök, Mustafa Verşan; Akın, Serhat (2008-01-01) The objective of this study is to investigate the applicability of Vapex process on Garzan crude oil. Experiments were performed with Hele-Shaw cell using two different solvents (propane and butane) at three different injection rates (20, 40, and 80 ml/min). For both Vapex solvents, oil production rates increased with injection rates for Garzan crude oil. Instantaneous asphaltene rate for Garzan oil showed fluctuated performance with propane solvent. Butane showed almost constant degree of asphaltene precip...
Feasibility study of heavy oil field Kök, Mustafa Verşan (Informa UK Limited, 2008-01-01) In this study, application of different enhanced tertiary oil recovery methods were applied considering fluid properties and reservoir characteristics of the heavy oil field. Effect of different oil and inflation rates were analyzed considering project economic life, pay out time, cash flow, and profit to investment ratio for steam flooding and CO2 methods. CO2 injection is found to be more profitable than the steam injection due to the high cost of steam injection operations and reservoir depth.
Characterization and Development of Drilling Fluid Type for an Oil Field Kök, Mustafa Verşan (Informa UK Limited, 2010-01-01) In this study, different types of drilling fluids are developed and analyzed for a mature oil field. The optimum conditions were developed for shallow and deep formations. The experimental procedure that was followed for viscosity, fluid loss, density, and pH calculations is based on the standards dictated by API RP 13B. At the end of the experiments, it was also observed that for shallow depths, 0.2-0.3 lb of caustic soda will be enough for one barrel of drilling fluid. On the other hand, lignosulphanate t...
Modeling of CO2 storage in an oil reservoir Gumrah, F.; Dulger, M.; Gunaydin, D.; Senel, O. (Informa UK Limited, 2008-01-01) This study provides an overview for the carbon dioxide sequestration process in an oil reservoir by using the software CMG's GEM. Different scenarios are applied for the oil reservoir description. Firstly, a single layered reservoir is considered and simulation studies are performed, as this reservoir is homogeneous, heterogeneous and fractured. Secondly, a multi-layered reservoir is examined. In the second case, a heterogeneous system and a heterogeneous system composed of homogenous layers are selected. F...

Citation Formats

M. V. Kök and S. Akın, “Application of vapex process for light crude oil,” ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS, pp. 20–26, 2008, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/41254.