Improved oil recovery using alkaline solutions in limestone medium

Date

2000-05-01

Author

Turksoy, U
Bağcı, Ali Suat

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

174
views

0
downloads

In this study, the effect of sodium hydroxide (NaOH) and sodium silicate (NaSiO4) solutions for the improved oil recovery of Garzan (26 API degrees) and Raman (17.2 API degrees) crude oils with variable salinity of the alkaline solutions, and the effect of injection flow rate at the salinity values of the alkaline solutions that yielded maximum oil recovery for both crude oils has been investigated using a one-dimensional unconsolidated limestone reservoir model. As the previous study, the interfacial tension measurements of the given crude oils and alkaline solutions interface have been measured to find the optimum concentrations of the alkaline that give the minimum interfacial tension at the crude oil/alkaline solution interface, at different salinity of the alkaline solutions. Using these optimum alkaline concentrations, 22 displacement runs have been performed; 13 runs with the variable salinity of the alkaline solutions, six runs with the variable injection flow rate, and the remaining three runs were the base floods, performed without oil to see the interaction of alkaline solutions with the porous matrix. The results of the displacement tests showed that the NaOH solutions with increasing salinity, has given the most significant incremental oil recovery, about 3-9% for Garzan crude oil, while the NaOH and NaSiO4 solutions with different salinity did not produced any significant incremental oil recovery for Raman crude oil, when compared with the base waterfloods performed for each crude oil types. Six displacement runs have been performed; three runs for Garzan crude oil and three runs for Raman crude oil at injection flow rates of 400, 300, 200 and 100 cm(3)/h for each crude oil with the salinity of the alkaline solution that yielded maximum oil recovery. The results of the displacement tests showed that injection flow rate of alkaline solution has an important effect on Garzan crude oil and has less effect on Raman crude oil in the scope of oil recovery achieved. The optimum injection flow rates for both Garzan and Raman crude oils have been found, which was 200 cm3/h for Garzan crude oil and 300 cm3/h for Raman crude oil for our model.

Subject Keywords

Limestone medium, Alkaline solutions, Oil recovery

URI

https://hdl.handle.net/11511/62466

Journal

JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING

DOI

https://doi.org/10.1016/s0920-4105(00)00025-5

Collections

Department of Petroleum and Natural Gas Engineering, Article

Suggestions

OpenMETU
Core

Improved oil recovery application in limestone reservoirs using alkaline solutions Bagci, S.; Kök, Mustafa Verşan; Turksoy, U. (Informa UK Limited, 2007-09-01) In this research, the effect of sodium hydroxide (NaOH) and sodium silicate (NaSiO4) solutions for the improved oil recovery of Raman crude oil was investigated using a one-dimensional unconsolidated limestone reservoir model. The results of displacement tests showed that sodium hydroxide (NaOH) and sodium silicate (NaSiO4) solutions were not effective on incremental oil recovery. It was also observed that injection flow rate of alkaline solution has minimum effect on Raman crude oil in scope of oil recover...
Development of a screening model for polymer flooding in multi-layer reservoirs ZarePakzad, Negar; Durgut, İsmail; Artun, Emre; Department of Petroleum and Natural Gas Engineering (2018) Polymer flooding is a chemical enhanced oil recovery method which aims to increase oil production from a water flooded oil reservoir by increase in water viscosity and reduction in water-oil mobility ratio. These changes result in significant increase in sweep efficiency of water comparing with water-only flooding technique. The objective of this study is to analyze the behavior of multilayer reservoirs under polymer flooding process, considering effects of reservoir characteristics, polymer properties and ...
Improved PEM fuel cell performance with hydrophobic catalyst layers Avcioglu, Gokce S.; FIÇICILAR, BERKER; Eroğlu, İnci (2018-10-04) Flooding of catalyst layers is one of the major issues, which effects performance of low temperature proton exchange membrane fuel cells (PEMFC). Rendering catalyst layers hydrophobic one may improve the performance of PEMFC depending on Pt percentage in the catalyst and Polytetrafluoroethylene (PTFE) loading on the electrode. In this study, effect of hydrophobicity in catalyst layers on performance has been investigated by comparing performances of membrane electrode assemblies prepared with 48% Pt/C. Ultr...
The effects of metallic catalysts on light crude oil oxidation in limestone medium Celebioglu, D; Bağcı, Ali Suat (2002-08-20) In this study, 28 experiments were performed to study the effects of metallic additives on light crude oil oxidation in limestone medium. Karakus and Beykan crude oils from Turkish oil fields were used. The metallic additives were ferric chloride (FeCl3) copper chloride (CuCl) and magnesium chloride (MgCl(2)(.)6H(2)O). The mixture of aqueous solutions of three metallic salts with limestone and the crude oils was subjected to a controlled heating schedule under a constant flow rate of air. The produced gas w...
Isolation of volatile oil from thyme (Thymbra spicata) by steam distillation Hanci, SS; Şahin, Serpil; Yılmaz, Levent (2003-08-01) The effects of steam flow rate (1.03 and 0.64 L/h), distillation time, and particle size (0.50, 1.00, 2.05 mm) of Thymbra spicata on essential oil yield and sequence of extraction of compounds were studied. A logarithmic model fitted well to experimental data. The composition of the essential oil obtained by steam distillation was investigated for whole leaves only since the grinding had an adverse effect on yield. The oil obtained was very rich with respect to its carvacrol content. For both steam flow rat...

Citation Formats

U. Turksoy and A. S. Bağcı, “Improved oil recovery using alkaline solutions in limestone medium,” JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING, pp. 105–119, 2000, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/62466.