Analysis and design of a low flow rate regulator.

Date

1978

Author

Bayrakçı, Sami

Metadata

Show full item record

Item Usage Stats

67
views

0
downloads

URI

https://hdl.handle.net/11511/7689

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

Analysis and design of a cuk switching regulator Günaydın, Zekiye; Ersak, Aydın; Department of Electrical and Electronics Engineering (2009) This theses analyzes Cuk converter, that is one of the dc to dc switchıng converters. For continuous inductor current mode and discontinuous inductor current mode, stedy state operation is analysied. Characteristic parameters are determined. Through State Space Averge Models, Small Signal Models are obtained. Parasitic Resistance effects on steady state and small signal models are determined. Efficency of the switching converter is derived. Open loop transfer functions for continous and discontinuous induct...
Analysis, design and construction of a percentage-ratio, second restraint differential relay for power transformer protection. Önbilgin, Güven; Department of Electrical Engineering (1977)
Analysis and design of a compliant variable stroke mechanism TANIK, ENGİN; Söylemez, Eres (Elsevier BV, 2010-10-01) In this paper, analysis and design of an underactuated compliant variable stroke mechanism are presented by employing its pseudo-rigid-body model (PRBM). During the design two cases are considered: prescribed output loading and constant input torque. It is shown that this mechanism is suitable where variable stroke is required corresponding to variable output loading. It is also observed that this mechanism is capable of providing nearly constant force over a wide range of input. The analysis and design app...
Analysis and design of a circularly polarized microstrip antenna Taştan, Mehmet; Koç, Seyit Sencer; Department of Electrical and Electronics Engineering (2006) In this study we tried to design a microstrip antenna, to get a suitable radiation pattern for a LEO satellite. Our aim is to get a radiation pattern that has a maximum power which is not in the broadside direction to the antenna surface; instead broadside radiation has a relatively lower power density. Maximum power radiation is desired to be at about 30 50 degrees angle beyond the normal to the antenna surface. We desire circularly polarized radiation. We used two concentric antennas; one is a circular p...
Analysis and design of preforms for non-axisymmetric press forgings Kutlu, Ali Erkin; Gökler, Mustafa İlhan; Department of Mechanical Engineering (2001)

Citation Formats

S. Bayrakçı, “Analysis and design of a low flow rate regulator.,” Middle East Technical University, 1978.