Modeling design and implementation of a parylene based micro electrophoresis system

2006-09-14
Sukas, Sertan
Külah, Haluk
Show full item record
87
views
0
downloads
https://hdl.handle.net/11511/77675
Unverified, Article

Suggestions

Modeling guided heat pipe design methodology and experimental validation for flat grooved heat pipes
Saygan, Samet; Dursunkaya, Zafer; Çetin, Barbaros; Department of Mechanical Engineering (2021-2-24)
Heat pipes are commonly preferred thermal management devices due to their rapid heat transfer characteristics, small size and reliability. It is crucial to design heat pipes that accurately match the requirements of the system to be thermally managed. In the present study, a numerical design and diagnosis simulation tool for heat pipes is developed and verified for grooved heat pipes. A modular heat pipe experimental setup is designed and manufactured. In order to decide on the geometric parameters of the h...
Modelling analysis and control of a wind turbine driven self-excited induction generator.
Üctuğ, M. Yıldırım; Demirekler, Mübeccel; Department of Electrical and Electronics Engineering (1986)
Modeling and Experimental Study of Newtonian Fluid Flow in Annulus
SORGUN, Mehmet; Ozbayoglu, M. Evren; Aydın, İsmail (2010-09-01)
A major concern in drilling operations is the proper determination of frictional pressure loss in order to select a mud pump and avoid any serious problems. In this study, a mechanistic model is proposed for predicting the frictional pressure losses of light drilling fluid, which can be used for concentric annuli. The experimental data that were available in the literature and conducted at the Middle East Technical University-Petroleum Engineering (METU-PETE) flow loop as well as computational fluid dynamic...
Modeling and experimental evaluation of variable speed pump and valve controlled hydraulic servo drives
Çalışkan, Hakan; Balkan, Raif Tuna; Department of Mechanical Engineering (2009)
In this thesis study, a valveless hydraulic servo system controlled by two pumps is investigated and its performance characteristics are compared with a conventional valve controlled system both experimentally and analytically. The two control techniques are applied on the position control of a single rod linear actuator. In the valve controlled system, the flow rate through the actuator is regulated with a servovalve; whereas in the pump controlled system, two variable speed pumps driven by servomotors reg...
Modeling, simulation and experimental verification of a hydraulic fan drive system
Toraman, Ersen; Balkan, Raif Tuna; Department of Mechanical Engineering (2013)
Environmental factors, global legislations and economic reasons force vehicle industry to produce more efficient systems. Displacement controlled hydraulic fan drive system is one of the energy efficient alternatives for stationary highway vehicles, construction machines and military vehicles that have moderate engine size and less benefit from ram air cooling. In this thesis study, hydraulic fan drive system of a military vehicle is investigated and a dynamic model of the system is developed. MATLAB/Simuli...
Citation Formats
S. Sukas and H. Külah, “Modeling design and implementation of a parylene based micro electrophoresis system,” 2006, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/77675.
METU IIS - Integrated Information Service open@metu.edu.tr