Evaluation of circuit performance of arbitrary connected multiterminal microwave networks

Download
012855.pdf
1991
Tünay, B. Gülsün
Show full item record
129
views
0
downloads
https://hdl.handle.net/11511/8498
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Evaluation of response time distributions for controller area network messages
Batur, Ahmet; Schmidt, Şenan Ece; Schmidt, Klaus Verner (2018-07-09)
The response time distribution (RTD) for messages on the controller area network (CAN) represents the probability of experiencing each possible response time. The existing literature suggests to use the RTD for the design of real-time applications based on CAN. This paper shows that the RTD does not capture the response time behavior on CAN well due to gradual clock drifts among CAN nodes. Instead
Evaluation of message weight distrubution polinomials for linear block codes
Kocatürk, Levent; Yücel, Melek D.; Department of Electrical and Electronics Engineering (1996)
Evaluation of Motion Selection and Scaling for the Nonlinear Seismic Analysis of Concrete Gravity Dams
Soysal, Berat Feyza; Ay, Bekir Özer; Arıcı, Yalın (null; 2017-10-13)
The selection and scaling of the ground motions is usually the most effective factor determining the results of the safety assessment for concrete gravity dams. The guidelines for the nonlinear transient analyses of buildings, such as the one presented in ASCE/SEI-7-10, are generally applied to these structures. While these procedures are well-studied for the moment frames, their effectiveness and consistency has not been studied for gravity dam structures. The selection and scaling of the ground motions fo...
Evaluation of effective elastic properties of honeycomb sandwich structures by optimization involving modal behavior
Çınar, Okan; Erdal Erdoğmuş, Merve; Kayran, Altan; Department of Mechanical Engineering (2014)
This thesis aims to develop an alternative approach which estimates the effective elastic properties of 2D orthotropic equivalent model of the honeycomb core material. For this purpose, 3D detailed finite element (FE) model of honeycomb structure, with the actual cell geometry and the face sheets, is used as the reference structure. Effective elastic properties of the equivalent 2D orthotropic model, representing the honeycomb core, are determined by means optimization. The objective function of the optimiz...
Evaluation of Inductance Measurement Methods for PM Machines
Ertan, Hulusi Bülent (2012-09-05)
For simulation purposes and developing controllers, accurate motor parameters are needed to successfully estimate motor performance. Plenty of research has been done on this issue. However, standard procedures are not established yet. This paper concentrates on the measurement of the most critical parameter for permanent magnet motors, namely motor inductances of such motors. Frequency dependence, current dependence and the effect of the power supply waveform on measurements are investigated. Tests are done...
Citation Formats
B. G. Tünay, “Evaluation of circuit performance of arbitrary connected multiterminal microwave networks,” Middle East Technical University, 1991.
METU IIS - Integrated Information Service open@metu.edu.tr