Ultra-thin Al2O3 capped with SiNx enabling implied open-circuit voltage reaching 720mV on industrial p-type Cz c-Si wafers for passivated emitter and rear solar cells

Date

2021-01-01

Author

Koekbudak, Gamze
Kececi, Ahmet E.
Nasser, Hisham
Turan, Raşit

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

239
views

0
downloads

In this study, we report on the passivation quality of atomic layer deposition grown ultra-thin Al2O3 and Al2O3 capped with plasma-enhanced chemical vapor deposition deposited SiNx on Cz p-type wafers for the rear side of a passivated emitter and rear cell (PERC). Different activation recipes using N-2, forming gas (FG), and two-step annealing for different durations are investigated before SiNx deposition. The effect of different Al2O3 thicknesses and corresponding activation processes on the Al2O3/SiNx passivation performance, after a high temperature firing step, is studied to reach a new optimization toward higher efficiency and lower cost. A record high iV(oc) of 720mV is obtained after firing step from Al2O3/SiNx stacks with Al2O3 thickness as thin as similar to 2nm with FG annealing. Our results demonstrate that, under well-optimized process conditions, ultra-thin Al2O3 thicknesses provide superior passivation quality as compared to the larger thicknesses which are commonly applied in the PERC industrial line and the potential for further improvement of industrial PERC solar cells in terms of cost reduction and efficiency.

Subject Keywords

Surfaces, Coatings and Films, Surfaces and Interfaces, Condensed Matter Physics

URI

https://hdl.handle.net/11511/88488

Journal

JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A

DOI

https://doi.org/10.1116/6.0000692

Collections

Department of Physics, Article

Suggestions

OpenMETU
Core

Optimization of n(+) nc-Si:H and a-SiNx:H layers for their application in nc-Si:H TFT ANUTGAN, TAMİLA; Anutgan, Mustafa; Atilgan, Ismail; Katircioglu, Bayram (Elsevier BV, 2011-02-25) The n-type doped silicon thin films were deposited by plasma enhanced chemical vapor deposition (PECVD) technique at high and low H-2 dilutions. High H-2 dilution resulted in n(+) nanocrystalline silicon films (n(+) nc-Si:H) with the lower resistivity (rho similar to 0.7 Omega cm) compared to that of doped amorphous silicon films (similar to 900 0 cm) grown at low H-2 dilution. The change of the lateral rho of n(+) nc-Si:H films was measured by reducing the film thickness via gradual reactive ion etching. T...
XPS analysis with external bias: a simple method for probing differential charging Ertaş, Gülay (Wiley, 2004-07-01) The XPS spectra of thermally grown oxide layers on Si, Al, W and Hf substrates have been recorded while the samples were subjected to external d.c. voltage bias. The bias induces additional shifts in the measured binding energy differences between the XPS peaks of the oxide and that of the metal substrate in Si and Al (as probed both in the 2p and the KLL Auger regions), but not in W and Hf (as probed in the 4f region). These bias induced shifts are attributed to differential charging between the oxide laye...
Enhanced peak separation in XPS with external biasing Ertaş, Gülay; Suzer, S (Elsevier BV, 2005-08-15) We have demonstrated that the An 4f peaks of the capped gold nanoparticles deposited on a SiO2 (20 nm)/Si substrate can be separated form the An 4f peaks of a gold metal strip, in contact with the same sample, by application of an external voltage bias to the sample rod while recording the XPS spectra. The external bias controls the flow of low-energy electrons falling on to the sample which in-turn controls the extent of the differential charging of the oxide layer leading to shifts in the binding energy o...
p-TlGaSeS/n-BN heterojunction as a microwave filter and as a photovoltaic device QASRAWI, ATEF FAYEZ HASAN; Omar, Ahmad; Azamtta, Ala' M.; Hasanlı, Nızamı (Wiley, 2015-03-01) In this work, a p-n junction made of p-type TlGaSeS and n-type boron nitride (BN) is investigated and characterized. The bilayer was studied by means of capacitance-voltage characteristics, current-voltage characteristics and Bode signal and photovoltaic effect diagnostics. It was observed that the pTlGaSeS/n-BN bilayer exhibits negative capacitance values in the frequency range of 30-80 MHz. For an ac signal of 30 MHz, the built-in voltage and density of noncompensating carriers for the device are found to...
Wrinkling of graphene because of the thermal expansion mismatch between graphene and copper Ogurtani, Omer Tarik; Senyildiz, Dogukan; Buke, Goknur Cambaz (Wiley, 2018-05-01) Well-defined bundles of wrinkles are observed on the graphene-covered copper by using atomic force microscopy after chemical vapor deposition process. Their numerical analyses are performed by employing a set of formula deduced from classical elasticity theory of bent thin films with clamped boundary conditions. Here they are imposed by the banks of trenches associated with the reconstructed copper substrate surfaces, which suppress lateral movements of graphene monolayers and induce local biaxial stress. T...

Citation Formats

G. Koekbudak, A. E. Kececi, H. Nasser, and R. Turan, “Ultra-thin Al2O3 capped with SiNx enabling implied open-circuit voltage reaching 720mV on industrial p-type Cz c-Si wafers for passivated emitter and rear solar cells,” JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, pp. 0–0, 2021, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/88488.