An automatic control system for electric discharge machining

Download
093027.pdf
2000
Altarjuman, Mohd Adham
Show full item record
142
views
0
downloads
https://hdl.handle.net/11511/2790
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

An automatic remote control system for radio receivers employing varactor diodes as tuning elements.
Gokce, Gurkan; Department of Electrical Engineering (1966)
A high voltage ignition and timing control system for internal combustion engine
Ergün, M Kemal; Hızal, Mirzahan; Department of Electrical and Electronics Engineering (1994)
AN AUTOMATIC ACCELERATION COMPENSATION SYSTEM FOR A SINGLE-MASS MEMS GYROSCOPE
Gavcar, H. D.; Azgın, Kıvanç; Alper, S. E.; Akın, Tayfun (2015-06-25)
This paper presents the architecture and experimental verification of an automatic acceleration compensation system applied to a single-mass MEMS gyroscope. The proposed method eliminates low frequency proof mass motion of the gyroscope due to external accelerations, suppressing the g-sensitivity of the gyroscope bias up to 12 times. This is achieved by dedicated acceleration cancellation electrodes ( ACEs) for the first time in the literature, eliminating any degradation of the sensor bias stability and no...
A Stand alone induction powered current and current harmonics measurement system for distribution lines
Gökgöz, Sinan; Hızal, Mirzahan; Department of Electrical and Electronics Engineering (2012)
The presence of information and communication technologies in the field of energy is increasing every day. Smart grid subject which aims to increase the percentage of energy generation through renewable resources and to make consumers to be involved in grid actively, is gaining importance day by day. In order to provide an e ffcient and reliable operation of smart grid network, it is necessary to collect relevant parameters from network components via communication infrastructure and to evaluate collected i...
A control system for hydraulic single axis durability test rig
Çalışkan, Hakan; Balkan, Raif Tuna; Platin, Bülent Emre; Konukseven, Erhan İlhan (2012-10-19)
In this study, a controller is designed for a hydraulic actuator of a single axis durability test rig. The mathematical equations of the system are derived and a MATLAB Simulink (R) model is developed. The non-linear equations defining the system dynamics are linearized and the system is represented in state space. For the position control of the hydraulic actuator, a combined feedforward and feedback controller is designed. The feedforward controller estimates the force transmitted between the vehicle and ...
Citation Formats
M. A. Altarjuman, “An automatic control system for electric discharge machining,” Middle East Technical University, 2000.
METU IIS - Integrated Information Service open@metu.edu.tr