Operation Analysis of an AC/DC Converter with Quasi-Active Power Factor Correction

Date

2011-09-10

Author

Rahmatian, M.
Moghani, J. Sh.
Abdi, B.
Gharehpetian, G. B.

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

200
views

0
downloads

In this paper an attempt has been made to analysis the operation of an ac/dc converter with quasi-active power factor correction. This investigation has been made in two steps. In the first step, an analytical investigation is made considering some logical assumptions. In the second step, one of the assumptions has been neglected for a more precise analysis and the principal operation of the circuit has been investigated analytically again. To confirm the accuracy of the theoretical analysis results, the circuit operation has been analyzed numerically and simulated. The obtained results admit the previous assessments.

Subject Keywords

ac/dc converter, Power Factor Correction (PFC), Dither signal

URI

https://hdl.handle.net/11511/67727

Collections

Department of Electrical and Electronics Engineering, Conference / Seminar

Suggestions

OpenMETU
Core

Operating principles and practical design aspects of all SiC DC/AC/DC converter for MPPT in grid-connected PV supplies ÖZTÜRK, SERKAN; Popos, Polat; Utalay, Volkan; Koc, Atila; Ermiş, Muammer; ÇADIRCI, IŞIK (2018-12-01) A 20 kW, 20 kHz high frequency (HF) link maximum power point tracking (MPPT) converter for a grid-connected PV supply, based on all silicon carbide (SiC) power semiconductors, is presented. In the developed converter, SiC power MOSFETs are used in the low-voltage PV panel side and SiC Schottky diodes on the high-voltage DC output, in order to maximize the power conversion efficiency and the power density. Operating principles of the resulting dual H-bridge MPPT converter and the practical aspects of the con...
Detailed Noise Analysis of Current-to-Frequency Converters for Precision Analog Accelerometers Nuzumlali, Omer Lutfi (2016-04-14) This paper presents a detailed noise analysis of current-to-frequency converters (CFC) for current output precision analog accelerometers. In the proposed method, time domain approach is used instead of frequency domain approach and the standard deviation of the velocity error after a fixed period of time is calculated. The noise analysis demonstrates that the error caused by voltage noises does not increase with time. However, the standard deviation of the error due to the feedback current noise increases ...
Steady-state modeling of a phase-shift PWM parallel resonant converter Iskender, Ires; Uctug, Yildurum; Ertan, Hulusi Bülent (2006-01-01) Purpose - To derive an analytical model for a dc-ac-dc parallel resonant converter operating in lagging power factor mode based on the steady-state operation conditions and considering the effects of a high-frequency transformer.
Dimension reduced robust beamforming for towed arrays Topçu, Emre; Candan, Çağatay; Department of Electrical and Electronics Engineering (2015) Adaptive beamforming methods are used to obtain higher signal to interference plus noise ratio at the array output. However, these methods are very sensitive to steering vector and covariance matrix estimation errors. To overcome this issue, robust methods are usually employed. On the other hand, implementation of these robust methods can be computationally expensive for arrays with large number of sensors. Reduced dimension techniques aim to lower the computational load of adaptive beamforming algorithms w...
Optimizing transient and filtering performance of a C-type 2nd harmonic power filter by the use of solid-state switches Gerçek, Cem Özgür; Ertaş, Arif; Department of Electrical and Electronics Engineering (2007) In this research work, the performance of a C-type, 2nd harmonic power filter is optimized by the use of a thyristor switched damping resistor. In the design of conventional C-type, 2nd harmonic filters; the resistance of permanently connected damping resistor is to be optimized for minimization of voltage stresses on filter elements arising from switchings in transient state and for maximization of filtering effectiveness in the steady-state. Transformer inrush current during energization of power transfor...

Citation Formats

M. Rahmatian, J. S. Moghani, B. Abdi, and G. B. Gharehpetian, “Operation Analysis of an AC/DC Converter with Quasi-Active Power Factor Correction,” 2011, p. 95, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/67727.