Performance comparison of inverter control techniques used for the supply of a linear PM synchronous actuator

Ben Salem, I.
Ouni, L. El Amraoui
Gillon, F.
Benrejeb, M.
Brochet, P.
This paper presents performance comparison of three inverter control techniques. These techniques are respectively hysteresis control, MAIM control and direct voltage control (DVC). They are applied for a PM Linear Tubular Synchronous Actuator (PAITI,SA) drive fed, using a three phase voltage source inverter (VSI). This VSI is working with constant switching time intervals as in the standard torque control DTC system.


Performance evaluation of a wind driven DOIG using a hybrid model
Cadirci, I; Ermiş, Muammer (1998-06-01)
This paper presents the performance analysis of a wind driven double output induction generator (DOIG) operating at varying shaft speeds. A periodic transient state analysis of DOIG equipped with two controlled converters is carried out using a hybrid induction machine model. It is shown that practical aspects of converters such as overlap and harmonics reduce the power output of the DOIG system and limit the operating shaft speed range, especially in the subsynchronous region near the synchronous speed. Va...
Robustness Adaptive Control For a Permanent Magnet Synchronous Motor
Rebouh, S.; Kaddouri, A.; Abdessemed, R.; Haddoun, A. (2011-09-10)
This paper presents a vector control permanent magnet synchronous motor drive using backstepping control design. Backstopping control is proposed for replacing the existing PI controller to obtain high performance motion control systems for the speed control loop. Stability analysis based on Lyapunov theory is also performed to guarantee the convergence of the speed tracking error from all possible initials conditions. Computer simulations have been carried out in order to validate the effectiveness of the ...
Performance Analysis of Reduced Common-Mode Voltage PWM Methods and Comparison With Standard PWM Methods for Three-Phase Voltage-Source Inverters
Hava, Ahmet Masum (2009-01-01)
This paper surveys the reduced common-mode voltage pulsewidth modulation (RCMV-PWM) methods for three-phase voltage-source inverters, investigates their performance characteristics, and provides a comparison with the standard PWM methods. PWM methods are reviewed, and their pulse patterns and common-mode voltage (CMV) patterns are illustrated. The inverter input and output current ripple characteristics and output voltage linearity characteristics of each PWM method are thoroughly investigated by analytical...
Comparison of Inverter Topologies Suited for Integrated Modular Motor Drive Applications
Ugur, Mesut; Sarac, Hakan; Keysan, Ozan (2018-08-30)
In this paper, various inverter topologies are compared for integrated modular motor drive (IMMD) applications. Two-level voltage source inverter (2L-VSI), three level voltage source inverter (3L-VSI) and series/parallel combinations of these topologies with system level modularity are compared in terms of voltage and current harmonic spectrum, passive component sizes and motor drive efficiency. New generation wide band-gap GaN power semiconductor devices are utilized in modular topologies and they are comp...
Design of a GaN Based Integrated Modular Motor Drive
Uğur, Mesut; Keysan, Ozan (2018-10-25)
In this study, design procedure of an Integrated Modular Motor Drive (IMMD) is presented focusing on high power density. The design is based on a permanent magnet synchronous motor (PMSM) and GaN FETs. Fractional slot concentrated windings are used on the stator. Slot/pole combination and winding configuration is selected based on having low cogging torque and high winding factor. An extended motor drive inverter topology is proposed where 2-level voltage source inverters are connected both in series and pa...
Citation Formats
I. Ben Salem, L. E. A. Ouni, F. Gillon, M. Benrejeb, and P. Brochet, “Performance comparison of inverter control techniques used for the supply of a linear PM synchronous actuator,” 2011, p. 720, Accessed: 00, 2020. [Online]. Available: