Design of a gas sampling valve to measure the scaveging efficiency of a two stroke engine.

1965
Azam Khan, Farooq
Show full item record
138
views
0
downloads
https://hdl.handle.net/11511/6836
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Design of a processor for splitting and shelling pistachio nuts.
Sipahi, Sina; Department of Mechanical Engineering (1975)
Design of an axial flow fan for a vertical wind tunnel for paratroopers
Çevik, Fatih; Albayrak, Kahraman; Department of Mechanical Engineering (2010)
Free fall is one of the important phases of the operation performed by the Special Forces paratroopers. Also civilian parachutists are performing free fall as a sport by doing aerobatic maneuvers when they reach the terminal velocity during falling before opening their parachutes. Vertical wind tunnels are used for training the parachutists and paratroopers. It is safe, cheap and more convenient when compared to jumping out of an airplane. This thesis consists of aerodynamic design of closed circuit, double...
Design of an inertia measurement device for stores
Kılıç, Berkay; Dal, Hüsnü; Tüzün, Aydın; Department of Mechanical Engineering (2018)
In this thesis, design of a device, which can measure mass properties of missiles or their sub-components in a single test setup, is expressed. An object, whose mass properties are going to be calculated, is attached to the device and three-dimensional, oscillatory motion about a specific point is supplied to that object. During this motion, velocity and acceleration values of the object are measured simultaneously with the force and torque values at the connection point. Mass properties of the object are c...
Design of a controller for image stabilization
Eroğlu, Rafet; Kocaoğlan, Erol; Department of Electrical and Electronics Engineering (2000)
Design of a video processing and system control board for a compact thermal imager.
Dinmez, Serkan; Beşikci, Cengiz; Department of Electrical and Electronics Engineering (2002)
Citation Formats
F. Azam Khan, “Design of a gas sampling valve to measure the scaveging efficiency of a two stroke engine.,” Middle East Technical University, 1965.
METU IIS - Integrated Information Service open@metu.edu.tr