Effects of Rotor Flux Barrier Design on Torque Ripple and High Speed Performance of Synchronous Reluctance Machines

Effects of array guided surface waves on radiation characteristics of a finite planar printed dipole array Aydın Çivi, Hatice Özlem; Pathak, PH (2004-06-26) The presence of surface waves different from the conventional grounded dielectric substrate surface wave modes, which can be excited on a finite periodic radiating array of printed dipoles, at frequencies for which the spacing between dipoles is typically less than half a wavelength is studied. The effects of such array guided surface waves on the array radiation characteristics are investigated. Techniques to suppress these surface waves are also discussed.
Effects of twin screw compounding conditions on the mechanical properties of Nylon-6 glass fiber composites Cansever, M; Yılmazer, Ülkü (2000-05-11) The effect of processing conditions on fiber length degradation was investigated in order to produce higher performance composites. For this aim. Nylon-6 was compounded with glass fibers in a twin screw extruder for various combinations of screw speed and feed rate. Collected samples were injection molded and izod impact and tensile strength tests were performed in order to observe the effects of fiber length on mechanical properties. Also, by using the extruded and injection molded samples. fiber length di...
Effects of THz Transmission on the Narrow Gap DC Glow Discharge Plasmas ALASGARZAGE, Namıg; Altan, Hakan; MANSUROĞLU, DOĞAN; Şahin, Asaf Behzat; Uzun Kaymak, İlker Ümit (2017-05-25)
Effects of RTM mold temperature and vacuum on the mechanical properties of epoxy/glass fiber composite plates Kaynak, Cevdet; Isitman, Nihat Ali (2008-08-01) The purpose of this study is to investigate the effects of mold temperature, application of vacuum at resin exit ports, and initial resin temperature on the mechanical properties of epoxy matrix woven glass fiber reinforced composite specimens produced by resin transfer molding (RTM). For this purpose, six mold temperatures (25, 40, 60, 80, 100, and 120 degrees C), two initial resin temperatures (15 and 28 degrees C), and vacuum (0.03 bar) and without vacuum (similar to 1 bar) conditions are utilized. Speci...
Effects of electrolyte pattern on mechanical and electrochemical properties of solid oxide fuel cells TİMURKUTLUK, BORA; Celik, Selahattin; Toros, Serkan; Timurkutluk, Cigdem; Mat, Mahmut D.; Kaplan, Yuksel (2012-09-01) In order to enhance the electrochemical performance and reduce the operation temperature of a conventional electrolyte supported solid oxide fuel cell (SOFC), a three layered electrolyte with various geometry is designed and fabricated. Novel three layered electrolytes comprise a dense and thin scandia alumina stabilized zirconia (ScAlSZ) electrolyte layer sandwiched between two hallow ScAlSZ electrolyte layers each having the same thickness as the support but machined into a filter like architecture in the...

Citation Formats

Y. B. Yılmaz and E. Bostancı, “Effects of Rotor Flux Barrier Design on Torque Ripple and High Speed Performance of Synchronous Reluctance Machines,” 2020, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/69742.